Can ProSeries 10K Square Jack PS1400960376 Be Used in Multiples

Question

Question:

Will two part # PS1400960376 work together or does it require a different follower unit?

asked by: Nick H

0

Expert Reply:

The ProSeries 10K Square Jack # PS1400960376 can be used singly or as a pair of two along with the Sidewind Crank Assembly # PS1400920383. This jack is not like landing gear jacks which do have a lead leg and a matching follow leg.

expert reply by: Adam R

0

Answer 1

The drop leg lever of the Pro Series jack #PS1400960376 that you referenced is actually front facing so instead of being able to point towards the outside of the trailer it would point to front. There isn't a version that has the lever parallel…

view full answer...

Answer 2

I spoke with my contact at Reese and he sent me dimensions of the Pro Series Jack, item # PS14009503676. I have included a drawing containing these dimensions for you to review. There is no owners manual included with these Jacks at this time. The…

view full answer...

Answer 3

I spoke to my contact at Pro-Series and he informed me that this Pro Series Square Jack, part #PS1400960376, has an outer jack housing length of 24 inches. Since the one currently on your trailer is about 23 inches this #PS1400960376 looks to be a…

view full answer...

Answer 4

Yes, you can use the Pro Series Square Jack #PS1400950376 in a dual setup as long as it is with the same model Pro Series jack like part #PS1400960376. Just be sure these are installed at the same height and your connecting rod is long enough for…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 8

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 9

The Lippert 2420801 hub is an 8k hub with an 8 lug bolt pattern so for a replacement you'd just need the part #8-285-10UC3-A.

view full answer...

Answer 10

I apologize for the confusion. It sounds like you have found some conflicting answers in the past, so I took the liberty to contact Bulldog directly and this is what they said: "The 12k RAM jack has a smaller diameter cross-shaft, therefore the…

view full answer...

Can ProSeries 10K Square Jack PS1400960376 Be Used in Multiples

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching