How are the Long Black Torx Wall Liner Screws Measured
Question:
I have a similar screw used on the plywood bed of my Floe snowmobile trailer. The screw I have is 1 1/4inch from the bottom of the head to the end of the drill tip. Question#1: Does your screw length include the drill tip in the overall length? Is the thread length 3/4inch plus the drill tip, 1/4inch for a total of 1inch length?? Question #2: is this type of a screw available in a longer length? Ive looked at your other screws for deck attachment and they dont appear to have the same size head as this screw.
asked by: Mike
Expert Reply:
The 1" Long Black Torx Wall Liner Screw part # WLS100 is measured from the head to the tip, so it is 1" long from the highest point to the lowest point. It uses a T25 bit like part # TX425.
We do have the Long Black Torx Wall Liner Screws available in 1-1/2" long part # TFX150, 2-1/4" long part # TFX225, and 2-1/2" long part # TFX250 but these use a T30 bit like part # TX430-1.
![Conner L](https://images.etrailer.com/static/images/catg/people/1234_tn.jpg)
Products Referenced in This Question
1-1/2" Long Standard Torx Trailer Floor and Wall Liner Screw
- Accessories and Parts
- Tie Down Anchors
- Hardware
- Torx Screw
- 1-1/2 Inch Long
- ABS Fasteners
more information >
2-1/4" Long Standard Torx Trailer Floor and Wall Liner Screw
- Accessories and Parts
- Tie Down Anchors
- Hardware
- Torx Screw
- 2-1/4 Inch Long
- ABS Fasteners
more information >
2-1/2" Long Standard Torx Trailer Floor and Wall Liner Screw
- Accessories and Parts
- Tie Down Anchors
- Hardware
- Torx Screw
- 2-1/2 Inch Long
- ABS Fasteners
more information >
Torx Head Screwdriver Bit for WLS100 Wall Liner Screw
- Accessories and Parts
- Tie Down Anchors
- Tools
- Torx Driver Bit
- Redline
more information >
Product Page this Question was Asked From
1" Long Black Torx Wall Liner Screw
- Accessories and Parts
- Tie Down Anchors
- Hardware
- Torx Screw
- 1 Inch Long
- Redline
more information >
Continue Researching
- Q&A: Replacement Screw for Trailer Jack with 1-1/4 Inch Diameter
- Q&A: Grease Seal Recommendation for 7,200 lb Dexter Hub
- Q&A: Door Hinge for 2001 Exiss Horse Trailer
- Article: Determining Trailer Tongue Weight
- Article: How to Measure for Trailer Hitch Drop
- Article: Trailer Wiring Diagrams
- Q&A: How does the Wire Frame Clip Attach to an Enclosed or Utility Trailer Frame
- Q&A: Converting Trailer from Surge Brakes to Electric Brakes
- Q&A: Electirc Brake Kit AKEBRK-8 Dimensions and Slipper Springs for 9,000 Pound Axle
- Article: How to Determine Tire/Wheel Diameter
- Q&A: How To Install the Spindle Nut on a 12,000 Pound Dexter Axle
- Article: How to Install E-Track in 3 Easy Steps
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Charge a Trailer Battery While Driving: 3 Common Problems (And How to Fix Them)