Amber LED Clearance Lights or Side Marker Lights Color and Installation

Question

Question:

Do these ship from Canada Mcl55A1224B And are these the darker amber and not so yellowish?

asked by: Paul F

1

Helpful Expert Reply:

The LED Trailer Clearance/Side Marker Light - 4 Diode, 12.8 Volts - Round - Amber # MCL55A1224B will have an orange/yellow color. They do have a darker amber lens than some other options on the market. I've attached a video to assist. They will ship from our warehouse in St. Louis area (Wentzville).

I've attached a review and an installation video to assist. These lights will use grommet # A54GB and wiring pigtail # A46PB or # A86PB.

expert reply by: Jason S

1

Answer 1

The "20327-02" light base is a rectangular shaped clearance light measuring 4" long x 2" wide which was made by Optronics. The light has since been discontinued along with the replacement lens but we have had customers use part…

view full answer...

Answer 2

Yes, you'd just need to reach out to a qualified welder and have them weld on spring seats like part #TRSS300 to the top side of the Trailer Axle Beam with Easy Grease Spindles #e45GR. It's super common to do for people who have an underslung…

view full answer...

Answer 3

The Kwikee Series 32 steps part #LC3722616 would work great to replace what you have on your 1998 Bounder. This is same setup you have now with some updated internal components which will last longer and be more reliable than what you have now. Due…

view full answer...

Answer 4

I was not seeing a way to replace the white wire you are refereeing too, so I reached out to the manufacturer regarding your issue. The manufacturer said that the only way to replace the white wire going into the motor head area would be to replace…

view full answer...

Answer 5

To determine the axle size you will need there are some measurements needed. First, if you are replacing the axle then you can measure the one you have. Measure from the center of one spring seat to the center of the other spring seat. Then measure…

view full answer...

Answer 6

Yes, you just have to remove the old lights, match the wires and mount the new ones. Please note, that it is usually not a good idea to mix LEDs and incandescent lights, so if you have have side markers or other lights on the trailer, make sure you…

view full answer...

Answer 7

Thanks for reaching out! Since the only difference between your 265/70-17 and 265/65-17 tire sizes is that the former has about 1" more diameter I think it's safe to say that a chain currently fitting on your 265/70 will also fit your…

view full answer...

Answer 8

The brake magnet is held onto an electric braking assembly with a clip. It is not impossible for these to work themselves out over time so I would make sure that you still have the clip in place. The clip is located inside the center of the magnet…

view full answer...

Answer 9

The closest Bearing Buddy we have to a 2-1/8 measurement is going to be a slightly larger set that measures 2.240 inches, #BB2240 or #BB2240SS. In order to determine the correct Bearing Buddy for your trailer, the best way is to get the inner and…

view full answer...

Amber LED Clearance Lights or Side Marker Lights Color and Installation

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching