Replacement Kwikee 32 Series RV Steps for 1998 Bounder RV

Question

Question:

i have a 1998 bounder with series32 kwikee 2 step I think the control box is bad Ihave power to box but with door open the steps stay in is there a direct replacement? or even a complete step replacement 83/4 X22 bolt pattern

asked by: Vince L

0

Expert Reply:

The Kwikee Series 32 steps part # LC3722616 would work great to replace what you have on your 1998 Bounder. This is same setup you have now with some updated internal components which will last longer and be more reliable than what you have now.

Due to age there isn't a control box available.

expert reply by: Jameson C

0

Answer 1

Thank you for the photos, that really helps! It looks like you're needing the 1-diode 2-1/2" round lights from Optronics; Red #MCL0040RBB and Amber #MCL0040ABB. The lens looks to be the same design and the bases have the same…

view full answer...

Answer 2

You will need the Lippert Components Kwikee Step Non-Skid Tape #LC381178 to replace the strip on your Kwikee Steps #LC3722616. We also have the Lippert Components Kwikee Step Glow in the Dark Tread #LC379600 if you want the added glow in the dark…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 8

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 9

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 10

It could be a tow package fuse on the vehicle. Use the owners manual to find the locations of fuses/relays related to the tow package wiring to check them and replace as needed. If the issue is not a fuse or relay then you can test the vehicle side…

view full answer...

Answer 11

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 12

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Replacement Kwikee 32 Series RV Steps for 1998 Bounder RV

Product Page this Question was Asked From

Continue Researching