What is the Height of the Fulton Boat Guide, # FBGR200101

Question

Question:

Is the 20 heighth of #FBGR200101 roller measured from the top of trailer frame location or to the bottom of the supplied u-bolts?

asked by: Carl L

0

Expert Reply:

The 20 inch height of the Fulton Boat Guide, # FBGR200101, is measured from the top of the horizontal part of the tube to the top of the vertical part of the tube where the padded part is. I made a picture for you that shows this measurement.

expert reply by: Michael H

0

click to enlarge

Answer 1

The Fulton Boat Guide, #FBGR200101, is at about a 20 degree angle from a vertical straight line. It does not have to be attached to a cross member on the trailer. It can attach just to the outermost side rail of the frame as long as the frame is up…

view full answer...

Answer 2

Based on the information I could find for the DICO 45264 is was popular on ShoreLand'r trailers. This would require the Idler Hub #AKIHUB-545-35-G-EZ-K with the Grease Seal #168255TB used instead of the seal included with the hub. We currently do…

view full answer...

Answer 3

Yes, the CE Smith Roller-Style Guide-Ons part #CE27610 will fit your EZ Loader boat trailer. The brackets work with trailer frames up to 3" wide x 4-1/4" tall so your 1-1/2" wide x 4" tall frame will not be an issue. I have…

view full answer...

Answer 4

the CE Smith guide-ons #CE27610 are approximately 15 degrees off 90 degrees. So that would be 75 or 105 degrees depending on which way the guide-on was facing.

view full answer...

Answer 5

Based on my research the 45264 model hub is designed for 3,500 pound axles and uses the #L68149 (1.378" inner diameter) inner bearing and #L44649 (1.063" inner diameter) outer bearing. The correct grease seal is #168255TB, which has a…

view full answer...

Answer 6

The only repair kit we have for your Profile 2000 hand winch is the Winch Ratchet Repair Kit by Dutton-Lainson item #DL70475. If this isn't what you are needing you will have to replace your winch. I recommend the Dutton-Lainson Hand Winch -…

view full answer...

Answer 7

Yes, the CE Smith Trailer Hub part #CE13511 will fit as a replacement for your DICO hub 45264 but you will need to use a different seal as we have found that your spindle diameter is slightly different which means you need the #168255TB as well.

view full answer...

Answer 8

Yes, the Malone MicroSport to LowBed Trailer Conversion Support Tubes #MAL33TR will allow you to transform your MicroSport Trailer #MPG461B2 into the LowBed #MAL25FR. This will make it much easier to load your kayaks or possibly we launch them…

view full answer...

What is the Height of the Fulton Boat Guide, # FBGR200101

Product Page this Question was Asked From

Continue Researching