What Angle Does the Fulton Boat Guide Stick Out and Does it have to Mount on a Cross Member

Question

Question:

1. What is the angle off 90 degrees? I have a SeaArk aluminum boat with 15 degree sides. 2. Will if work if i installed it only on the 3x5 trailer frame or do I have to install it on a cross member of the trailer as well.

asked by: Steve H

1

Helpful Expert Reply:

The Fulton Boat Guide, # FBGR200101, is at about a 20 degree angle from a vertical straight line.

It does not have to be attached to a cross member on the trailer. It can attach just to the outermost side rail of the frame as long as the frame is up to 3 x 5 inches.

expert reply by: Michael H

1

Answer 1

From the end of the tube, to the point where the bend starts is 8.75 inches. In some of the other pictures you can see where the tube begins to narrow as the bend starts.

view full answer...

Answer 2

The 20 inch height of the Fulton Boat Guide, #FBGR200101, is measured from the top of the horizontal part of the tube to the top of the vertical part of the tube where the padded part is. I made a picture for you that shows this measurement.

view full answer...

Answer 3

Yes, the CE Smith Roller-Style Guide-Ons part #CE27610 will fit your EZ Loader boat trailer. The brackets work with trailer frames up to 3" wide x 4-1/4" tall so your 1-1/2" wide x 4" tall frame will not be an issue. I have…

view full answer...

Answer 4

Based on my research the 45264 model hub is designed for 3,500 pound axles and uses the #L68149 (1.378" inner diameter) inner bearing and #L44649 (1.063" inner diameter) outer bearing. The correct grease seal is #168255TB, which has a…

view full answer...

Answer 5

the CE Smith guide-ons #CE27610 are approximately 15 degrees off 90 degrees. So that would be 75 or 105 degrees depending on which way the guide-on was facing.

view full answer...

Answer 6

Yes, the CE Smith Trailer Hub part #CE13511 will fit as a replacement for your DICO hub 45264 but you will need to use a different seal as we have found that your spindle diameter is slightly different which means you need the #168255TB as well.

view full answer...

Answer 7

I have another option for you, but you are correct that the CE Smith Multi Sport Plus Boat and Kayak Trailer w/ Bunks #CE48870 can only handle boats up to 14' long. You instead would need to use the Malone LowBed MicroSport Trailer #MPG464-LB…

view full answer...

Answer 8

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

What Angle Does the Fulton Boat Guide Stick Out and Does it have to Mount on a Cross Member

Product Page this Question was Asked From

Continue Researching