Recommended Trailer Hitch and Cargo Carrier for Wheelchair on 2006 Ford Focus ZX5
Question:
Can’t find a hitch for Ford Focus 2006 that is class 3 for a wheelchair carrier for my handicapped daughter that will help us get her around to places. We have to break the wheelchair down and back if we go out to a few places and it is hard enough lifting her and putting her in and out. This would make it where we don’t have to keep breaking the chair up and down in between destinations and could just take her out of car and roll chair to her instead of breaking down every time and putting chair in and out of the trunk. The carrier I have found calls for a hitch that is class 3 or better. Car: 2006 Ford Focus zx5 ses
asked by: Micah
Expert Reply:
Your 2006 Ford Focus ZX5 SES does not have a hitch that is rated past 200 lbs tongue weight or class 1 with the 1-1/4 inch receiver based on the way the vehicle is made and its capacities. My recommendation is the 19x47 Curt Cargo Carrier # C18110 which weighs 30 lbs. The weight of the carrier needs to be subtracted from the 200 lb hitch capacity to give you the remaining cargo capacity for the wheelchair.
For your trailer hitch, I recommend the Draw-Tite Sportframe Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4" # 24692 over the Curt # C11294 simply because it doesn't require the stability strap # 18050 like the Curt hitch does.
If the wheelchair is heavier, then you'd need to use a trailer for transport.
Products Referenced in This Question
Curt Cam Buckle Stabilizing Strap for Hitch-Mounted Accessories - 61" x 1" - Qty 1
- Accessories and Parts
- Hitch Bike Racks
- Hitch Cargo Carrier
- Tie Down Straps
- CURT
more information >
Draw-Tite Sportframe Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4"
- Trailer Hitch
- Custom Fit Hitch
- Class I
- 200 lbs TW
- 2000 lbs GTW
- 1-1/4 Inch Hitch
- Visible Cross Tube
- Draw-Tite
more information >
19x47 Curt Cargo Carrier for 1-1/4" and 2" Hitches - Steel - 300 lbs
- Hitch Cargo Carrier
- Flat Carrier
- Fixed Carrier
- 20 Inch Wide
- Standard Duty
- Fits 1-1/4 and 2 Inch Hitch
- Fits 1-1/4 Inch Hitch
- Fits 2 Inch Hitch
- 48 Inch Long
- Class I
- Class II
- Class III
- Class IV
- Steel
- CURT
more information >
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4"
- Trailer Hitch
- Custom Fit Hitch
- Class I
- 200 lbs TW
- 2000 lbs GTW
- 1-1/4 Inch Hitch
- Visible Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Ball Mount Basics: Weight Capacity, Class, and Size
- Q&A: Hitch Recommendation For A 2016 Ford Focus SE Hatchback
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Can 3 Spacers be Used for Curt 11294 Hitch Install on 2007 Ford Focus
- Q&A: What is the Difference Between Class 1 and Class 2 Hitches for the Scion XB
- Q&A: Can Trailer Valet XL Be Used on Sloping Driveway
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Trailer Wiring Harness Options for 2007 Ford Focus
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Q&A: Aftermarket Vehicle Harness Only Running Lights Work On 2011 Ford Escape
- Q&A: How to Carry a 222 Pound Motorcycle with a 2006 Ford Focus
- Article: Routing the Power Wire for a Trailer Wiring Harness
- Article: Trailer Wiring Diagrams
- Article: Trailer Hitch Installation Tips