Which Way Should the Arrow Point on a Catalytic Converter

Question

Question:

I have a cat that has an arrow on the bottom of it it does have the O2 sensor port in the cat which way should the arrow Port towards the header or towards the muffler

asked by: Jp

0

Expert Reply:

The arrow on your catalytic converter should be aligned with the direct of flow for exhaust gases. Therefore, the arrow would need to be pointed towards the muffler, not the header/exhaust manifold.

expert reply by: Conner L

0

Answer 1

If your Catalytic Converter does not have an arrow on it then it is likely not directional. This will allow you to mount it on your exhaust without a direction.

view full answer...

Answer 2

I spoke with my contact at MagnaFlow and found out that the universal fit catalytic converter is reversible so it does not matter which way the flow goes. If you can tell me the year, make, and model of the vehicle i can tell you what converter…

view full answer...

Answer 3

The best way to increase power with your 1990 Ford Ranger is by adding a catalytic converter, which is going to be a specific fit for your truck based on the engine it has. - 2.3L I4 Engine: MagnaFlow Stainless Steel Catalytic Converter - Direct-Fit…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 9

For your 2007 Ram 3/4 ton, I'd recommend the Curt #C31017 which would mount to the underside of the frame members and would have the receiver tube sitting directly under the front bumper. I spoke with my contact at Draw-Tite who confirms that…

view full answer...

Answer 10

Since wire color codes are NOT universal, we always recommend wiring by function, rather than wire color. If you look at the Trailer Wiring FAQ article I have linked you to, you can see some diagrams showing the proper way to wire a vehicle and…

view full answer...

Answer 11

There's a few differences. • The Curt #C31017 is manufactured in the US, while the Draw-Tite #65046 is manufactured in Mexico. • When installed, the Curt hitch will sit higher on the vehicle for more ground clearance. The underside of the…

view full answer...

Answer 12

I contacted my Curt Manufacturing rep, who tells me the total drop of their #C31017 is 4-1/4 inches. The drop is the distance from the top surface of the mounting flange that would sit flat against the underside of the frame members to the lowest…

view full answer...

Which Way Should the Arrow Point on a Catalytic Converter

Product Page this Question was Asked From

Continue Researching