Is Lippert Ground Control 2.0 System Compatible with 3.0 Motor and Leg?

Question

Question:

hello, i recently found that my 2 yr old 5th has the 2.0 ground control instead of the 3.0 I had a forward leg gear failure and ordered the 2.0 leg. would a 3.0 leg work, as it is just a leg and motor, i would thing that it would still get the levelinginch signal from the head control and act accordingly. Hate to buy a whole new system because Lipert is no long building parts for my 2yr old obsolete system! Thanks in advance

asked by: Phil S

0

Expert Reply:

The Lippert 2.0 system is not compatible with the motors on the 3.0 system. The 3.0 system uses electric motors that utilize the hall effect where the 2.0 system does not. This is a completely different design which makes the motor and legs incompatible with the controller and wiring of the 2.0 system.

You will need to upgrade your system if you desire that style as your system has been replaced. For the 2.0 system we have the Replacement Heavy-Duty Landing Gear Jack Leg for Ground Control 2.0 - Short # LC241844 and Replacement Heavy-Duty Landing Gear Jack Leg - Extended # LC241845.

To upgrade your system we have the Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad and Remote - 4-Point Set # LC358590 or 6 point set # LC675817. A complete system is required for the upgrade.

expert reply by: Jason S

0

Answer 1

Yes, we do have what you're looking for! For your Replacement Heavy-Duty Landing Gear Jack Leg for Ground Control 2.0 #LC241844, you can use the: -Replacement Aluminum Gearbox for Stromberg Carlson Landing Gear #LG-179015. If you are needing…

view full answer...

Answer 2

I reached out to my contact at Lippert and he said there are a couple of things you will want to look at to try and troubleshoot the blank display on your Level Up touch pad. He said to first remove the pad itself from where it's mounted (keeping…

view full answer...

Answer 3

We do indeed offer the replacement leg you mentioned as part #LC241844.

view full answer...

Answer 4

The Lippert Ground Control 3.0, 4-Point #LC358590 OR 6-Point #LC675817, comes with a 1-year limited warranty.

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 7

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 8

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

view full answer...

Is Lippert Ground Control 2.0 System Compatible with 3.0 Motor and Leg?

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching