Is a Transmission Filter Extender Required With a Derale Transmission Pan Cooler on 2001 Ford F350

Question

Question:

Do I need a filter extender for my ford f350 ,2001 tramission?????

asked by: Colin S

0

Expert Reply:

You should not need to use a filter extender to install this Derale Transmission Pan Cooler # D14208 in your 2001 Ford F-350. I spoke with my contact at Derale to confirm this also.

expert reply by: Jameson C

0

Answer 1

The Derale pan style transmission cooler #D14208 will fit your 1994 Ford F-150 with the 4.9 liter engine and E4OD transmission. You will not need to change the dipstick to test the fluid level.

view full answer...

Answer 2

On your 1996 C1500 Suburban, you can use an additional cooler in addition to a factory cooler without any noticable decrease in pressure. It will help to cool your transmission fluid further and the cooler with fan will allow you to mount it almost…

view full answer...

Answer 3

Only the return line gets disconnected from the factory cooler when installing a transmission cooler like the Derale Transmission Cooler part #D13502. Basically you remove the return line for the factory cooler, connect the inlet or the supplemental…

view full answer...

Answer 4

The fit for this Derale Transmission Cooler Pan #D14208 that you referenced is based on what transmission is in your 2002 Ford F-350 truck. If you have a 5.4,6.8, or 7.3 liter engine and E40D, 4R100, 5R100 or 5R100W transmission this is the correct…

view full answer...

Answer 5

Transmission fluid should run below 200 degrees Fahrenheit. At 240 degrees you definitely need to make some sort of change to reduce the temperature. I would first recommend having the transmission checked by a qualified automotive technician to be…

view full answer...

Answer 6

My technical contact at Derale confirmed that you will use your stock transmission filter on your 1997 Ford F-350 Powerstroke when installing the Derale Transmission Pan Cooler #D14208. To install this properly your truck must have either the E4OD,…

view full answer...

Answer 7

The depth of the Derale Transmission Pan Cooler #D14208 that you referenced measures 6-1/8 inches from the mounting surface of the pan down to the bottom of it. You would need to measure from where you current pan mounting surface down 6-1/8 inches…

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 11

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 12

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Is a Transmission Filter Extender Required With a Derale Transmission Pan Cooler on 2001 Ford F350

Product Page this Question was Asked From

Continue Researching