Clearance Over Crossbars of Rhino-Rack Ski and Snowboard Carrier

Question

Question:

Do the Rhino-Rack Ski and Snowboard Carrier - Locking - 6 Skis or 4 Boards come with the risers to allow for more clearance between the roof and rack?

asked by: John

0

Expert Reply:

The Rhino-Rack Ski and Snowboard Carrier # RR576 sits 3-5/8" over your crossbars but there are no risers available to give it additional clearance.

I have added a link to a video review of this carrier for you to check out as well.

expert reply by: Kyle S

0

Answer 1

The Rhino-Rack Ski and Snowboard Carrier, #RR576 is marketed for 6 pairs of skis or 4 boards and is 27-9/16" Long. The Rhino-Rack Fishing Rod Carrier, #RR576F has the same dimensions but uses the F identifier at the end to associate with…

view full answer...

Answer 2

Replacement Mounting Hardware for Yakima PowderHound, Big PowderHound or FreshSesh Item #Y8860040 will indeed fit around the 2-1/2 inch wide flat crossbars on your 2010 Subaru Forester. This is one assembly so for the Yakima ski carriers this was…

view full answer...

Answer 3

I spoke to my contact at Rhino Rack and he informed me that the dimension you are looking for is 29-1/4. The Rhino Rack Ski Carrier part #RR576 that you referenced will take up 29-1/4 inches of your crossbars. I attached the picture you submitted…

view full answer...

Answer 4

Aside from a slight change in the appearance of the crossbar (the WingBar Evo has some boxed edges as opposed to the completely smooth front of the AeroBlade) the biggest differences are the rubber strip on top of the crossbar and the weight…

view full answer...

Answer 5

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 6

The Rhino-Rack Heavy-Duty Roof Rack Roof Rack have specific C-channels that are designed to fit specific Rhino-Rack Heavy-Duty accessories, like the Rhino-Rack Hi-Lift Jack and Shovel-Holder Brackets #RRRCB-RSHB-RJHB as an example. That's the…

view full answer...

Answer 7

Hey Alec, For your 2016 Ford Fusion I recommend the recommend a roof rack from Inno: Inno Aero Crossbars #INXB138-145 Inno Through Feet for Aero Crossbars #INXS250 Custom Fit Kit for Inno XS200, XS250, and INSU-K5 Roof Rack Feet #INK860 As with any…

view full answer...

Answer 8

Thanks for reaching out, Joe! I recommend using the Rhino-Rack Aero Bar Roof Rack for Camper Shells #Y02-480B which comes with 63" long tracks as well as 54" long crossbars which should give you a little bit of overhang on your canopy. Per…

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 11

The Rhino-Rack Roof Rack for Factory Tracks #Y02-490B-NT is going to be your best bet for the tracks on the ARE topper for your 2012 Toyota Tacoma. The weight capacity is 220 lbs like you mentioned, but that's going to be the highest you'll…

view full answer...

Answer 12

The Rhino-Rack Aero Bar Roof Rack for Camper Shells part #Y02-480B is a great option for fiberglass truck bed campers as it was made for this exact purpose. It can support up to 220 lbs but bear in mind this rating is tested independently of the…

view full answer...

Clearance Over Crossbars of Rhino-Rack Ski and Snowboard Carrier

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching