Will Yakima Ski Carrier Replacement Mounting Hardware Fit 2010 Subaru Forester 2-1/2" Crossbars

Question

Question:

Will these mounts for my 2010 Subaru Forester flat cross bars, they are 2.5 inch wide?

asked by: Olga

0

Expert Reply:

Replacement Mounting Hardware for Yakima PowderHound, Big PowderHound or FreshSesh Item # Y8860040 will indeed fit around the 2-1/2 inch wide flat crossbars on your 2010 Subaru Forester. This is one assembly so for the Yakima ski carriers this was designed for you would need a total of 4.

expert reply by: Michael H

0

Answer 1

The correct replacement mounting hardware for your Yakima ButtonDown 6 Ski Carrier is the part #8830021. This is a direct replacement and will allow your carrier to fit round or square crossbars. If you want to be able to use the carrier on wider…

view full answer...

Answer 2

I went out to the warehouse to measure the clamps on Rhino Rack Ski Rack #RR573 and found that it was approximately 4" from center-to-center of the screw holes, with the screws themselves being 1-1/2". The clamps are roughly 1/4"…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

Aside from a slight change in the appearance of the crossbar (the WingBar Evo has some boxed edges as opposed to the completely smooth front of the AeroBlade) the biggest differences are the rubber strip on top of the crossbar and the weight…

view full answer...

Answer 5

For a roof rack to be compatible on your 2020 Jeep Wrangler with Sky One-Touch Power Top, it can't be mounted on the top of the roof and it needs to be high enough for the folding roof to clear. What you need are tall gutter-mounted roof racks.…

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 8

You could leave off installing the outside wheel clamp of the RockyMounts WestSlope bike rack part #RKY10222 but you can't shorten the frame of the rack where the wheel mounts are. For a bike rack with a smaller footprint that can carry up to two…

view full answer...

Answer 9

Hey Alec, For your 2016 Ford Fusion I recommend the recommend a roof rack from Inno: Inno Aero Crossbars #INXB138-145 Inno Through Feet for Aero Crossbars #INXS250 Custom Fit Kit for Inno XS200, XS250, and INSU-K5 Roof Rack Feet #INK860 As with any…

view full answer...

Answer 10

The Rhino-Rack Heavy-Duty Roof Rack Roof Rack have specific C-channels that are designed to fit specific Rhino-Rack Heavy-Duty accessories, like the Rhino-Rack Hi-Lift Jack and Shovel-Holder Brackets #RRRCB-RSHB-RJHB as an example. That's the…

view full answer...

Answer 11

We have a variety of roof rack solutions for the bare roof on your 2024 Chevy Equinox, and for your application I recommend the Rhino-Rack ROC25: - Rhino-Rack ROC25 Roof Rack for Naked Roofs #RR53TR This uses clamps on your door jambs but it has the…

view full answer...

Will Yakima Ski Carrier Replacement Mounting Hardware Fit 2010 Subaru Forester 2-1/2" Crossbars

Product Page this Question was Asked From

Continue Researching