Recommended JT Strong Arm Stabilizer Kit with Adapter Kit for Lippert Power Jacks

Question

Question:

2018 Rockwood 8328bs Has Lippert power jacks On the adapter kit for the jt strong arm do I need adapter kit for rear jacks or just front. How many kits do I need

asked by: Tom

1

Helpful Expert Reply:

For your Lippert power jacks like # LC369774, you will want one Lippert Components JT's Strong Arm Jack Stabilizer Adapter Kit for Electric Stabilizer Jacks # LC314597 for two Lippert jacks. You will use one tab on each foot to allow clearance for correct operation. It sounds like you have two Lippert power jacks, but you will only need one JT Strong Arm kit and one adapter kit.

This will allow you to use the Lippert Components JT's Strong Arm Jack Stabilizer Travel Trailer Kit # LC191025. I've attached a photo to assist.

expert reply by: Jason S

1

click to enlarge

Answer 1

The Road Armor Shock Absorbing Equalizer Kit part #LC696740 are taller than most other standard equalizers so you'll likely need the longer 3-1/8" shackle straps when using them, the Lippert AP Kit part #LC52SV is a go-to for this as…

view full answer...

Answer 2

Based on the information I could find on your 2023 Jayco Jayfeather 30QB travel trailer it appears you are going to have 4,400lb axles. You are going to need to verify the diameter of your current axles as some manufacturers like Lippert use a…

view full answer...

Answer 3

I contacted MORryde and this does happen from time to time as the weight of the trailer can spread out the axles due to downward pressure on the springs/suspension. Odds are the 35" wheel base #MR27ZR will be the correct one for you, but they…

view full answer...

Answer 4

The Dexter 072-078-00 is a 2,200 lb capacity leaf spring. You can use a higher capacity leaf spring, however it won't increase the capacity of your trailer as the axle is still rated for that max capacity of 4,400 lbs. My recommendation for a…

view full answer...

Answer 5

Yes, axle spread and wheel base by definition are the same measurements. You will measure from the center of one axle to the center of the 2nd axle to determine what you axle spread is. This may be difficult as some wheels and covers will make this…

view full answer...

Answer 6

Hey John, To determine the correct replacement leaf springs for your trailer you'll want to jack up one side to take the pressure off the leaf springs and then can measure from the center of one eyelet to the center of the other eyelet. From…

view full answer...

Answer 7

As you have a Coleman Mach system currently you can use the Furrion Chill AC units from the list below. These will simply replace only the rooftop units and the controls and thermostats you currently have in place with control the new AC's. 13.5K…

view full answer...

Recommended JT Strong Arm Stabilizer Kit with Adapter Kit for Lippert Power Jacks

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching