Is Bulb Already Installed on Trailer Stop, Turn and Tail Light

Question

Question:

Does the light come with the bulb installed

asked by: Richard M

0

Expert Reply:

Yes, the Trailer Stop, Turn and Tail Light, 6-Function, Right Hand # ST8RB does come with the bulb installed.

The matching light for the left side of your trailer is the Trailer Stop, Turn, Tail and License Plate Light, 7-Function, Left Hand # ST9RB, which also has the bult installed.

expert reply by: Kyle S

0

Answer 1

The Optronics Right-Hand Trailer Stop, Turn and Tail Light, Part #ST8RB, connects with two wires. On the rear of the housing are holes to accept bare wire and underneath each one is a smaller hole that serves as a wire release; just insert a small…

view full answer...

Answer 2

LED lights draw considerably less amperage than incandescent lights. They also run much cooler. These 2 features are why LED lights last so long. The incandescent version of #STL8RB is #ST8RB and it draws 2.5 amps for the stop/turn signal functions…

view full answer...

Answer 3

Changing the bulb is simple. Remove the screw on each corner of the front of the lens and gently pry the lens away from the housing. Be careful not to damage the gasket between the lens and the housing as doing so will allow water into the interior…

view full answer...

Answer 4

The bulb that's in the #ST8RB light is an 1157 like part #A1157B. To change the bulb remove the front lens by taking off the screws and gently prying the lens away. Then to get the bulb out you'll need to push in on it a bit and twist the…

view full answer...

Answer 5

If you have the Optronics #ST8RB and #ST9RB, no connector is needed. On the back of the taillight, there is a hole for the stop/turn and a hole for the running light wire. Each of these holes will have a smaller hole directly below it. Strip back the…

view full answer...

Answer 6

It sounds like you are referring to the Optronics Right Hand Trailer Light #ST8RB and the Left Hand #ST9RB. The only difference between the two assemblies is that the Left Hand/Driver's Side unit features an additional license plate light to…

view full answer...

Answer 7

Running a direct ground up to the trailer tongue or junction box would certainly work, but the only time I'd see that as being necessary is if the lamps were connected to a non metallic structure or a metallic structure that wasn't directly…

view full answer...

Answer 8

You should not have a problem using the Trailer Stop, Turn and Tail Light, 6-Function, Right Hand #ST8RB on the left and right hand sides of your trailer. It would be just a matter of wiring up the lights accordingly. On the #ST8RB there is an arrow…

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

Based on the dimensions you listed the equalizer you need is the part #TREQE1. This equalizer has 7-3/4 inches between the mounting holes from left to right and 2-7/8 inches vertically.

view full answer...

Answer 11

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 12

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...