RV Grill Mounting Rail Recommendation for Aussie RV Grille

Question

Question:

I have a aussie bbq 277000091and was wanting to know if I can get just the hanger bracket for it.

asked by: Bill K

0

Expert Reply:

Sounds like you are looking for an RV grill mounting rail like the part # CAM57268 for mounting your Aussie grill like the part # 277-000091.

expert reply by: Jameson C

0

Answer 1

That portion would be grill specific. While the Camco RV Grill Mounting Rail #CAM57268 is a universal rail that works with most grills the other parts are not as universal.

view full answer...

Answer 2

Torque specs for wheel lug nuts will vary depending on the diameter of the lugs, type of lug nut and the wheel's material. The linked chart details the recommended torque for many combinations. Dexter Hub/Drum #84546UC3 has 1/2-inch studs…

view full answer...

Answer 3

I can help you with greasing up your EZ Lube Axle. First thing I would check would be that the grease is not coming out of the back of the axle through the seal. If this is the case you will need to replace the seal. Our tubes like #L11390 have 14…

view full answer...

Answer 4

The battery on the trailer will not charge if it is attached to the 12V power wire from the towing vehicle. It will provide a small amount of current that helps maintain the current charge of the trailer battery. I recommend using a battery charger…

view full answer...

Answer 5

I will start by saying that Camco highly recommends that the Camco RV Grill Mounting Rail #CAM57268 is installed by a qualified RV dealer. However, if you are going to install the rail yourself; there is not a "set" way for installation.…

view full answer...

Answer 6

You will want to make sure that you have proper support behind the fiberglass location you plan on mounting this rail too. I was able to go out to the warehouse and find that on the product Camco recommends this product be installed by a qualified RV…

view full answer...

Answer 7

The longest Camco RV Grill Mounting Rail we have is the 16-1/2" item #CAM57268 you were looking at.

view full answer...

Answer 8

The Camco RV Grill Mounting Rail part #CAM57268 is designed to be used with a rail on an RV grill like the Faulkner BBQ Grill part #FR51323. You would need to obtain a bracket similar to that on the grill and attach that to the table as the Camco RV…

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 11

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 12

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…

view full answer...

RV Grill Mounting Rail Recommendation for Aussie RV Grille

Product Page this Question was Asked From

Continue Researching