Replacement Tarp for Extang FullTilt SL Soft Tonneau Cover on 2009 GMC Sierra 1500

Question

Question:

I have a 2009 GMC Sierra 1500 crew cab w/ 5 foot 8 inch bed. Im looking for a replacement tarp for the extang full tilt. Theres no part numbers on the existing hardware or tarp except for the Extang Fulltilt and a phone number tag on the passenger rear corner. Thanks for the help.

asked by: Justin T

0

Expert Reply:

There is a replacement cover that could work for you, but without a part number I would not be able to absolutely guarantee it.

Having said that, the Extang FullTilt SL Soft Tonneau Cover - Snapless J-Strip - Hatch Style # EX38645 is a fit for the 5-1/2 foot bed on your 2009 GMC Sierra 1500. The replacement tarp for this tonneau cover is the Replacement Cover for Extang FullTilt SL Vinyl Tonneau Cover - Snapless J-Strip - Hatch Style # EX37940, which is what may work for you.

expert reply by: Kyle S

0

Answer 1

The Replacement Tarp for Extang FullTilt SL Soft Tonneau Cover #EX37355 is not the correct replacement tarp for your Extang FullTilt tonneau cover, instead you'd need the Replacement Tarp for Extang FullTilt SL Soft Tonneau Cover #EX37425.

view full answer...

Answer 2

I just spoke with my rep at Extang and he confirmed that the item #EX37560 is the full tilt replacement cover for your 1997 Chevrolet S-10 fleetside truck.

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 6

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

Increasing the tire and wheel size can increase the height of the trailer but it's usually quite minimal. Before you do anything else you should see if the pin box can be adjusted. Although you have to be careful here since This will lower the…

view full answer...

Answer 9

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 10

The Progressive Dynamics Replacement Section #PD4655V does have a jumper to change the charging profile to lithium compatible. You'll simply need to move the black jumper over from the WIZ side to the LI side.

view full answer...

Answer 11

Choosing the right height setting for your 5th wheel hitch is a combination of a few different variables. First of all you want your towing setup to be as level as possible. With your Montana High Country 340BH level you will want to measure from the…

view full answer...

Replacement Tarp for Extang FullTilt SL Soft Tonneau Cover on 2009 GMC Sierra 1500

Product Page this Question was Asked From

Continue Researching