Double Lip Trailer Hub Grease Seal for Bearing # L44649

Question

Question:

Looking for double lip grease seal for 1964 Tee Nee trailer with bearing L44649. Current seal is 1.6 id and 1.9 od.

asked by: John

0

Expert Reply:

It sounds like you need a 10-60 seal, part # RG06-020. It has a 1.5 inch innder diameter and 1.987 outer diameter. It also fits a BTR spindle which bearing # L44649 is both the inner and outer for.

If you need the complete bearing kit use part # BK1-150.

expert reply by: Charles S

0

Answer 1

The grease seal that is commonly used with the hubs that have inner/outer bearings of L44649 is the #RG06-020. These seals have an inner diameter of 1.50 inches and an outer diameter of 1.987 inches. You can measure yours to determine if this would…

view full answer...

Answer 2

The best way to select a new hub is to match it based on the bearing set used in the original part. New hubs must use the same bearings as your old ones in order for them to fit on your spindles, so if you can find the part numbers from your inner…

view full answer...

Answer 3

For marine applications the best type of grease seal is a "double lip" seal which has a rubber spring that wraps around the seal to help hold it tight to the spindle so that it doesn't leak water. So for a double lip seal…

view full answer...

Answer 4

I can help you determine how to figure out the grease seal you need, although a trailer spindle won't have an inner and outer seal; the Timken bearings you referenced seem to be automotive bearings and there wasn't a cross-reference that will…

view full answer...

Answer 5

If you are looking for a grease cap PLUG with the TRP stamped on it chances are the Grease Cap Plug for E-Z Lube Grease Caps #RG04-010 would work for you, but to be certain you will want to measure the diameter of the grease cap hole. If it is 1.18…

view full answer...

Answer 6

The seal set you need is the part #RG06-020 which is a confirmed fit as a replacement for what you have.

view full answer...

Answer 7

With the measurements you got, the closest we will have is the #AH15450ECOMP. This is an agricultural hub the uses the outer bearing #LM11949, which does match the .75", but the inner bearing does not match. This uses a #LM67048 that has a…

view full answer...

Answer 8

Good news, I can help you pick out which hub kit will work with your 5 Starr Boat Trailer. I was able to look up your boat trailer and the parts used between packages varied. I can help you pick out which hub kit will fit if you can provide me with…

view full answer...

Answer 9

We will have several different pre packed hub assemblies for you to choose from depending on if you need a hub for drum brakes or hubs for an idler axle. Here is a list of hubs for both drum and idler axles in the different bolt patterns that use the…

view full answer...

Answer 10

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 11

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 12

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...