Timbren Suspension Kit Recommendation for 2007 Four Winds 32 Foot Motorhome

Question

Question:

i would like to get the Timbren suspension system but on the webpage it says not confirmed to fit my 2007 four winds 32foot motorhome do you have the the rear system to fit.

asked by: Gary

1

Helpful Expert Reply:

Your 2007 Four Winds 32 chassis is a Ford F-53 chassis so for a Timbren kit you'd want the # TFRF53A which is a confirmed fit for the rear and part # TFFF53B for the front.

expert reply by: Jameson C

1

Answer 1

Because the LED Porch and Utility Light for RVs #OPT24WR uses diodes instead of bulbs the entire light would need to be replaced. If your porch light has bulbs in it then you have a different light than the #OPT24WR. Typically the bulb itself will…

view full answer...

Answer 2

Believe me when I tell you, of all the questions we get, this is definitely NOT a stupid one, and to answer your question, both the Timbren Rear Suspension Enhancement System #TFRF53A and Timbren Front Suspension Enhancement System #TFFF53B will fit…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

Roadmasters priority when it comes to their sway bars is top notch quality and the easiest install for the customer. This typically cuts the install time down enough that you end up saving money if you pay to have the bars installed or decide to do…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

The Hellwig Adjustable Big Wig Rear Anti-Sway Bar #HE94FR is only going to leave a few inches between it and the spare tire, as you can see in the attached picture. Depending on how far forward you have the tire it could potentially interfere with…

view full answer...

Answer 7

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 8

Hey Robert, thanks for reaching out! You are correct that you'll want to install the rear Hellwig Anti-Sway Bar #HE78RR first on your '22 Entegra Odyssey 26D, and then if you still need more help you can install the front Hellwig Anti-Sway…

view full answer...

Answer 9

The SuperSprings Custom Suspension Stabilizer and Sway Control Kit #SSA22 is listed to fit and install above the leaf springs on your 2019 Coachmen Leprechaun 319MB. I tried looking up a photo of the suspension on your motorhome but I could find…

view full answer...

Answer 10

Hi there David; we do have truck camper jacks that can work for your F-250 with a lift and large tires. What you can use are camper jacks from Brophy, which have a 17" to 67" lift range, which is the highest possible lift height. There are…

view full answer...

Answer 11

I recommend starting with the Roadmaster Rear Anti-Sway Bar, #RM-1139-147. This will reduce side-to-side movement for a noticeable improvement in your vehicle's stability and reduced body roll. For the front, I recommend the Timbren Front…

view full answer...

Answer 12

You're already on the right track with everything you looked at. Your 2018 Thor ACE 30.3 has a GVWR of 18,000 lbs so I recommend the following: -Roadmaster Exact Center Steering Stabilizer w/ Custom Brackets for Class A Motorhomes #RM33RR…

view full answer...

Timbren Suspension Kit Recommendation for 2007 Four Winds 32 Foot Motorhome

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching