Replacement Lippert Components Venture 5th Wheel Landing Gear Motor

Question

Question:

What landing gear motor do I need to fit a Lippert 276602 Venture aluminum fifth wheel landing gear box?

asked by: Dan

0

Expert Reply:

If you know you need the Replacement Gearbox for Venture Aluminum Electric 5th Wheel RV Landing Gear # LC276602 then the correct motor would likely be Lippert Components Venture 5th Wheel RV Landing Gear Motor # LC142178 which is for Venture landing gear.

expert reply by: Kyle S

0

Answer 1

The replacement motor for your Lippert Venture VMC940RB would be the Replacement Motor for Stromberg Carlson Electric Landing Gear Set #LC196308. The Replacement Gearbox #LC276602 is correct too if you needed that as well.

view full answer...

Answer 2

If it will raise and lower electrically but not manually that would make me think it has something to do with the gear box but there isn't a clutch setup in that gear box that would normally fail. For a replacement you'd need Replacement…

view full answer...

Answer 3

The Go Power Industrial Pure Sine Wave Inverter, #34278156 that you linked to, is rated for 2,000 Watt. To operate anything for an extended period requiring this size inverter, I suggest at least a battery bank of at least 400 AH minimum. The…

view full answer...

Answer 4

While I don't know exactly what landing gear you have on your 2011 Keystone Raptor 3812 Toy Hauler, I can say that you should be able to replace them with the Landing Gear Set w/ Handle #RVLG-8HDL as this landing gear uses the standard weld mount…

view full answer...

Answer 5

We have the same part number basically twice through two different vendors here that are the exact replacement motor you are looking for. The Lippert part #LC142178 and the Stromberg part #LG-142178. They are the exact same motors and if I were you I…

view full answer...

Answer 6

The replacement motor for your landing gear is #LG-142178 This will work well for you.

view full answer...

Answer 7

Since you have a Dometic AC unit the best option to replace it from Advent would be the part #ACDOM135 which was designed for this exact situation and would allow you an easy install since the electronics would plug right in.

view full answer...

Answer 8

Assuming your Sprinter has the factory tow package with the 7-way at the rear bumper, in addition to the #RED24FR Redarc Tow-Pro Liberty Brake Controller, you'll also need the #3063-P wiring harness and the #331-TPH-017. The connector to install…

view full answer...

Answer 9

What you need for your Isuzu NPR truck is a powered converter #C59236. It is compatible with incandescent and LED trailer lights. I have included a link to the installation instructions for you. This harness does require a direct connection to the…

view full answer...

Answer 10

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 11

Slipper Springs like #e33SR do not use a bolt and bushing for the open eye end of the spring. It connects directly to the hanger using a slipper spring hanger kit.

view full answer...

Answer 12

We have a great option in a replacement 45 amp power converter for your ELX-45. I suggest the Progressive Dynamics, #PD4045KA. This is a 2-in-1 AC/DC distribution panel and smart charger that works with lithium-ion, flooded lead acid, AGM, and gel…

view full answer...

Replacement Lippert Components Venture 5th Wheel Landing Gear Motor

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching