Replacement Arm Knob for Thule Spare Me 2 Bike Rack

Question

Question:

Hi, I have this product: Thule Spare Me 2 Bike Rack - Spare Tire Mount - Folding Dual Arms And the knob that locks the folding bar in place is broken. Do you guys carry a replacement ? Thank You

asked by: Jason

0

Expert Reply:

For your Thule Spare Me 2 Bike Rack # TH963PRO, you will want the Replacement Arm Knob # 753-0737-10.

expert reply by: Jason S

0

click to enlarge

Answer 1

You would simply order a lock cylinder keyed to your existing key. For instance, if your key number was 123, you would order lock #THLOCKN123. Replace the 123 with the number of your existing key. You can type the part number into the search box on…

view full answer...

Answer 2

We have what you need here. First, though, the Locking Knob with Bolt for SportRack Single-Arm, Hitch-Mounted Bike Carriers, part #SR0018, is not compatible with the Thule Spare Me Bike Rack, part #TH963PRO. The correct bolt for that bike rack is the…

view full answer...

Answer 3

If you're really close you can just use the Long Standoff Extension Adapter item #852-3305-001 for your Thule Spare Me or Thule Spare Me 2 Bike Rack item #TH963PRO. It works for both bike racks whether you have the single or the double. This one…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

You are correct that this refrigerator does not have an ON/OFF switch or function. The best you can do is "Standby" that draws an unknown amount of power. One option is to pull the 12-Volt fuse at the RV power center. A much better option…

view full answer...

Answer 7

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 10

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 11

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 12

The Dometic RV Water Heater - Gas - Automatic Pilot - 12 Volt - 8,800 Btu - 6 Gal Tank Item AT96121 is the direct replacement for the GC6AA-10E. Unfortunately it is out of stock with no expected restock date. Instead I recommend the Furrion RV…

view full answer...