Replacement 10 Gallon Atwood Water Heater Recommendation for Jayco Designer Series RV  

A lot of the older Atwood water heaters have been discontinued, yes. For your replacement I recommend the Atwood RV Water Heater #AT94022 which is a 10 gallon gas/electric unit like you currently have with an automatic pilot. This uses 120V power…

I would definitely replace all tires at the same time if possible but if you can't then put the new tires on the axle that has brakes, if either have brakes. If both have brakes then put them on the rear axle if it is a regular straight axle;…

To replace your Atwood RV Water Heater, Model #GC10A-4E, the direct replacement is the Atwood RV Water Heater - Gas and Electric - part #AT94022. This is the new version of your existing water heater, so it will have all the same features like a…

We have the Super Grip Chock XL Wheel Stabilizer for Tandem-Axle Trailers #UF21-001094 which can fit wheel spaces of up to 17 inches. For a pair you would then want the part #UF21-001095.

I'd go with the part #UF21-001091. It locks the tire of each axle so well to each other that the trailer would not roll at all if pushed while you were hitching up. I attached a review video for more info. If you wanted to be super cautious a…

It sounds like you need to re-calibrate the zero point on your Lippert Ground Control 3.0 #LC304136 system. Below I've listed out the steps you'll need to follow and will allow you to use the auto leveling again. Zero Point Calibration The…

The best replacement option we offer for a Atwood GC10A-4E Water Heater is tankless, the Furrion RV Tankless Water Heater part #FR68SR. It won't be a direct replacement but still pretty easy nonetheless as they are very similar. That said, you…

Hey David, from previous customers of ours who have the same 2020 Keystone Raptor 424 we have determined that your pin box style is the Lippert 1621 which means for a Gen-Y gooseneck adapter you'd want the #GY58GR that you referenced.

The only tank equipped RV water heat option we currently offer is the Dometic RV Water Heater part #DMC74FR which is a 120 volt unit with 6 gallon tank and gas/electric operation. In regards to installation, this must be performed by a qualified…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

The cone that you see in the picture you attached of the Curt Crosswing part #C86JR is there to help align it with the rest of the hitch when you back the vehicle up into it and lower it down with the jacks. This ensures it is completely seated and…

The centerline on the #BR27FR is going to be from the center of the hitch pin hole. If you draw a line straight out and measure the distance to the bottom of the hook that is 1". I have attached a diagram below for your reference.