Need Replacement Center Cap for Americana Series 6, 15 Inch Wheel

Question

Question:

Hi, Do you have replacement caps available for Series 06 15 wheels, too? Thanks

asked by: Robert

0

Expert Reply:

Yes, the replacement center cap you will need for your Americana Series 6 Trailer Wheel is the Americana Trailer Wheel Center Cap, part # AM90091. This wheel center cap also has a shiny finish like the Americana Wheel Cap, part # AM90092.

The representative at Americana informed me that the Wheel Center Cap # AM90091 will fit any bolt pattern of the Americana Series 6, 15 inch wheel.

expert reply by: Reno H

0

Answer 1

For your 14 inch diameter Hi Spec Series 6 wheel that you sent in a picture of the correct wheel center cap is the part #AM90098.

view full answer...

Answer 2

We have a large selection of trailer hubs with a 6 on 5-1/2 bolt pattern. In order to determine if any of these will fit onto the spindle for your trailer, you will need to remove one of the hubs and check for the bearing numbers on the existing…

view full answer...

Answer 3

While it is true that the Americana Trailer Wheel Center Cap #AM90092 does have that center plug, this center cap is only available as a kit so to replace the center plug you'll need a whole new cap. I confirmed this with my contact at…

view full answer...

Answer 4

Yes we do! The Americana Trailer Wheel Center Cap #AM90091 referenced in your question is specifically designed for the 15 inch Americana #AM22651 or #AM20455 Aluminum Trailer Wheels. Please note that the current models of these wheels actually…

view full answer...

Answer 5

You want to check the wheel pilot hole diameter, its overall wheel diameter and its bolt pattern to match a center cap. The part you referenced, Americana Trailer Wheel Center Cap Series 06 #AM90091, fits a specific 15-inch wheel with a 5-hole bolt…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

Assuming your Sprinter has the factory tow package with the 7-way at the rear bumper, in addition to the #RED24FR Redarc Tow-Pro Liberty Brake Controller, you'll also need the #3063-P wiring harness and the #331-TPH-017. The connector to install…

view full answer...

Answer 8

Yes, the Solera Slide Topper part #LCV000168106 is the correct fit for your flange width of 90-1/2 inches. This specific model has a box width range of 86 to 91-3/4 inches which is perfect for your width listed.

view full answer...

Answer 9

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 10

According to my research, your 92865A-1 hub/drum has a 25580 inner and an 14125A outer bearing and a 8 on 6-1/2 inch lug pattern, as does the AxleTek #AKHD-865-7-2-K hub drum you referenced. The #AKHD-865-7-2-K would be an acceptable replacement for…

view full answer...

Answer 11

The Trailer Leaf Spring, 2250 lbs. 6 Leaf, item #e27SR, is sold as a replacement spring for older trailers and measures 26 inches for eye to eye, center to center. If you are replacing the springs and hangers you will need to use the same center to…

view full answer...

Answer 12

When installing/adjusting the Solera RV Slide-Out Awning #LCV000163285 tension is applied by rotating the awning roller 14 times. This should apply the needed spring tension so that the fabric doesn't billow in the wind or leave enough slack that…

view full answer...

Need Replacement Center Cap for Americana Series 6, 15 Inch Wheel

Continue Researching