How Far Does Pin of Ultimate Trailer Jack Go into the Jack

Question

Question:

How far does the pin go into the jack? I'm worried about it coming out when there's weight on the trailer.

asked by: Jennifer B

0

Expert Reply:

The Ultimate trailer jack, part # 322-RDJ-2K, has a pin used to drop the jack tube. As long as the pin is fully engaged and the safety pin is inserted it will hold up to the 2,000 pounds the jack is rated for. The pin goes completely through the jack to be sure it can support the weight.

expert reply by: Charles S

0

Answer 1

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...

Answer 2

Unfortunately I did not get the pictures, but I do have an idea of what you are looking for based on your description. I recommend the Ultimate Trailer Jack - A-Frame - Topwind - 27-1/2" Lift - 2,000 lbs #322-RDJ-2K. I've attached a video of…

view full answer...

Answer 3

The inner portion of the Ultimate Trailer Jack #322-RDJ-2K is not available separately. You'd need to order the whole assembly to get that part of it.

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 6

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 7

The three most common lug stud sizes for a trailer are 1/2"-20, 9/16"-18, and 5/8"-18. In order to make sure you get the correct lug nuts you need to measure the lug studs on the trailer now as we have no way to look this up for…

view full answer...

Answer 8

Your math is correct in your trailer weight load example. If a fully-loaded tandem axle trailer weighs 4000-lbs then each of the 4 tires will bear 1/4th of that load, or 1000-lbs. In this case a tire rated for 1300-lbs would provide a good safety…

view full answer...

Answer 9

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 10

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…

view full answer...

Answer 11

A BT8 spindle would have a diameter of .99 of an inch where the bearings would both install and would have a diameter of 1.24 where the great seal would ride. That would require a hub part #AKIHUB-440-2-1K for an idler hub. A BTR spindle would have…

view full answer...