How to Install the Curt TriFlex Trailer Brake Controller Part # C24VV on a 2016 Ram 1500

Question

Question:

I have a 2016 Dodge Ram1500 BigHorn. I wish to install aftermarket brake control Curt C24VV and harness 51458. Truck did not come with the OEM controller and wish to install the Curt 51140. Is there anything i would need to do at the Dodge dealer or just simply plug into the factory harness?

asked by: Brett

0

Expert Reply:

The Curt TriFlex Trailer Brake Controller part # C24VV coupled with the Curt Custom Wiring Adapter part # C51458 will have everything you need to install a brake controller on your 2016 Ram 1500. You will not need to take the vehicle to the dealer to install this as the process is very simple and should not take you more than 30 minutes or so. The hardest part of the whole process is finding the brake controller plug-in port on the vehicle. If you take a look at the attached installation video on a similar controller, you can see that the plug-in port on your Ram is located under the driver side dash panel about where your right knee will be located while seated as shown at the 3:30 second mark.

expert reply by: Conner L

0

Answer 1

We likely have a toolbox which will work with your Aluma 548 trailer although A-Frame toolboxes are not made specifically to fit certain trailers so you will need to know the amount of room you have to fit the box. I do recommend going with a…

view full answer...

Answer 2

The Air Lift AirLift 1000 Air Helper Springs for Coil Springs will work in the exact manner you want; improving the ride and how your 2014 Ram 1500 handles when you are towing. These air springs will reduce the strain on your Ram's suspension…

view full answer...

Answer 3

You can pretty easily install a friction sway control system on the driver side of a trailer. You would just need to remove the inner piece of the system like part #83660 and then rotate it 180 degrees and reinsert it into the outer piece. You…

view full answer...

Answer 4

To add sway control to your 2018 Audi Q7 towing setup I highly recommend the Tuson Asymmetric Sway Control #335TSC-1000. I really like this unit because it activates the brakes on your trailer (per side as needed) when it senses the trailer start…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two…

view full answer...

Answer 9

Hi Jeff; thanks for the question and sturdy is definitely a good word for the etrailer tonneau that fits your 2022 Ram 1500 with a 5-1/2 foot bed, the etrailer Hard Tonneau Cover #e35DR. It's made of a fiberglass-reinforced plastic which is a…

view full answer...

Answer 10

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 11

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 12

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...