Suspension Enhancement Recommendation to 2005 Jayco Seneca Built on Chevy Kodiak 5500

Question

Question:

I would like to add heavy duty Sumo Springs to my R.V. It is a 05/06 Jayco Seneca on a Chevrolet Kodiak chassis rated @ 26000 GVW. What would you recomend. Thanks

asked by: Norm L

0

Expert Reply:

For your 2005/2006 Jayco Seneca that's built on Chevy Kodiak 5500 chassis we have the SuperSprings suspension kit part # SSA25. This type of suspension enhancement is great because it also works as almost a sway bar to help improve the handling of the vehicle as well as increase the suspension support.

expert reply by: Jameson C

0

Answer 1

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 2

I'm assuming your 2024 F-250 has the 6-3/4' bed. If that is correct, the right tie-downs are in fact the #TLF3008 and #TL77CR. TorkLift has accounted for the bed access steps on the 2024 model and confirmed these will fit your truck.

view full answer...

Answer 3

Hey Shawn, yes the Air Lift Single Needle Gauge Panel part #AL26161 does have a light built into it. The spade connectors on the back of the gauge you'd run to the running light circuit which will light up when headlights are on.

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

According to RoadActive Suspension the spring rate for the standard kit #RAS3611-S is 2,400 lbs. For the heavy duty #RAS3611-SHD it is 3,600 lbs. The heavy duty #RAS3611-SLHD is the same but only designed to fit if you have factory top overload…

view full answer...

Answer 6

Hi there David; we do have truck camper jacks that can work for your F-250 with a lift and large tires. What you can use are camper jacks from Brophy, which have a 17" to 67" lift range, which is the highest possible lift height. There are…

view full answer...

Answer 7

For your 2023 Ford F-250 built after the 1st of the year you have a few different option SuperSprings. You will want to select the correct system based on the amount of weight you intend to carry. 1,400LB #SS94VR 2,500LB #SSA22 3,400LB #SSA25 The…

view full answer...

Answer 8

Hey J, thanks for reaching out! Air bag suspension kits are vehicle specific both for the mounting hardware and the bags themselves. After looking at what the manufacturers list as fits for your 2005 Ford F-350, I'm not seeing that anyone has…

view full answer...

Answer 9

Hey Shawn, good catch checking that on your 96 Ram. So you have a couple options. You could add a 1/2 inch wheel spacer to your rear axle to gain the additional clearance to use the part #F2071. Or you could go with the only option we have that works…

view full answer...

Answer 10

The SuperSprings #SSA22 would be a smart choice to raise your 2012 Ford F-250 when pulling your fifth wheel. They are designed to prevent the sagging you are experiencing and should put you pretty close to level. If you take a look at the attached…

view full answer...

Answer 11

The upper brackets for Firestone air bags #F2220 bolt through the frame but the frame brackets for Curt gooseneck hitch #C60734 do not have holes in them to accommodate this so this particular set up will not work together. If you could tell me if…

view full answer...

Suspension Enhancement Recommendation to 2005 Jayco Seneca Built on Chevy Kodiak 5500

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching