Availability of Cross Shaft for Use with Bulldog Jack BD182804

Question

Question:

Hi, Im designing a gooseneck trailer and I am considering BD182804. I want to be able to place the crank at the side of the frame with a single jack in the middle. Do you have an extension that can go between the jack and the crank?

asked by: Ubong E

0

Expert Reply:

We have the fixed cross shaft extension tube part # BDCS730300 which could be used to extend out the crank of the Bulldog Jack part # BD182804 that you referenced. This shaft is 72-3/4 inches long though which might be too long depending on the width of your trailer.

expert reply by: Jameson C

0

Answer 1

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and…

view full answer...

Answer 2

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 3

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 4

The old version of the #HBA-CAM used 4 wires, but the product was updated awhile back and now uses only two wires as shown in the photo on the product description page. The white wire from the HBA-CAM would tap into the white ground wire and the blue…

view full answer...

Answer 5

Since Demco uses 3,500 drum brake assemblies part #DMSB24429M and #DMSB24428M what you'd need is similar 3,500 electric brake assemblies like the etrailer part #AKEBRK-35L-SA for the left hand side and #AKEBRK-35R-SA for the right hand side. To…

view full answer...

Answer 6

The number you provided, "7753400" is a patent number which corelates to the Equalizer for E-Z Flex Suspension part #013-144-03. This is for a single equalizer but if you need the entire kit it's the Dexter E-Z Flex Suspension Kit part…

view full answer...

Answer 7

The 40 amp fuse for your 2006 Chevrolet Silverado tow package is used for the 12 volt battery charge circuit. This fuse is located toward the front of the underhood fuse box closest to the front auxiliary positive post (see photo). There may be a…

view full answer...

Answer 8

For your enclosed trailer application I have several suggestions for adding interior lighting that you can control directly via a switch. Since your current 4-pole trailer wiring does NOT include a 12V auxiliary power feed that could power inside…

view full answer...

Answer 9

The Titan Hitch Box Extension and Reducer for 2-1/2" Trailer Hitches, #RP45292, is a confirmed fit for your 2012 Chevrolet Silverado 2500 HD short bed with a Lance camper. This extension is specifically designed for your slide-in camper with the…

view full answer...

Answer 10

The Reese Titan Extension/Reducer you referenced, part #RP45292 would work great with the 2-1/2 inch Class V hitch on your Ram. As you mentioned, the extension has a 8K capacity when cut down to the 24 inch length, that will provide a 2 inch receiver…

view full answer...

Answer 11

You can use a 7-Way and 4-Way connector at the same time just as long as you are not overloading the light circuits. If your camper has a lot of outside lights like running lights, and brake/stop/turn lights then the lights that perform the same…

view full answer...

Answer 12

There is a Titan hitch extender that should work for you, but would require a Titan hitch be installed on your truck to handle a tongue weight loaded that far from the hitch. It is Reese part #RP45292. You can use it as a 34 inch extension or cut it…

view full answer...

Availability of Cross Shaft for Use with Bulldog Jack BD182804

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching