What Does Pro Series Cargo Carrier Ramp # PS1040200 Look Like Installed

Question

Question:

Can you still fold the cargo rack up when you have the ramp attached to it??

asked by: Jeffrey

0

Expert Reply:

I attached a picture of what the Pro Series Ram part # PS1040200 looks like when installed on a # PS1040100 for you to check out. This is a fixed cargo carrier that does not fold up.

expert reply by: Jameson C

0

click to enlarge

Answer 1

I check with the manufacturer and they told me that yes the hitch shank on the Pro Series Solo Cargo Carrier #PS1040100, can be flipped either way to help with clearance when opening the cargo area door on your 2003 Ford Explorer. You will just need…

view full answer...

Answer 2

I'm assuming that you're needing to know so you can choose the correct wiring harness, correct? You could call your Lexus dealer and give them your VIN, and they should be able to tell you how your RX350 is equipped. Or, you could remove the…

view full answer...

Answer 3

The Lil Rocker fifth wheel hitch you have is designed to fit the same industry standard fifth wheel rails as the current hitches made so we have several hitches that would work. The Reese Hitch part #RP30047 would be a great option. It has a 16k…

view full answer...

Answer 4

The Fulton Economy Spare Tire Carrier with Wheel Nut Lock #FETCSTL0701 would work just fine on a section of angle iron that is 3 inches by 2 inches. The frame does not have to completely fill out the U-bolt to allow the carrier to install. I attached…

view full answer...

Answer 5

I have attached the installation instructions for the Hopkins Engager Trailer BreakAway Kit, part #20099. This kit includes a charger and an LED tester and will work with single and tandem axle trailers. I have also attached a link to an installation…

view full answer...

Answer 6

I contacted the manufacturer, CargoSmart, who told me the length of the ramp, not including the tabs of the CargoSmart Loading Ramp Set #3483075, is 72-3/4". The frame is 50" wide, and the thickness of the frame is 1-3/4"; they also…

view full answer...

Answer 7

The width of a trailer wheel is measured from the inner edge of a bead to the inner edge of the other bead. If you take this measurement it should be 5 inches on your wheel. Take a look at the video I have linked that shows how to measure. You can…

view full answer...

Answer 8

We have heard of this issue before on the Lippert Ground Control systems #LC358590. Here is the recommended procedure for clearing the error code: Extend all jacks at least 6 inches. Then press and hold the RETRACT button until the jacks begin…

view full answer...

Answer 9

I'll start off by saying that because of the extra movement that can occur at the rear of an RV, you can only use a cargo carrier with a solid shank in the receiver on the back of your 2005 Class C on a Sprinter chassis; this also means that…

view full answer...

Answer 10

You will still be able to use the hands free lift gate feature on your 2021 Mazda CX-9 with the Curt Trailer Hitch Receiver #C13284 installed, but you will need to put your foot on either side of the receiver and move it in and out until you find the…

view full answer...

Answer 11

Yes, there is a set of crossbars that will fit the factory side rails of your 2023 Mazda CX-9. These mount directly to the side rails and will have more than enough capacity for a bike rack or cargo box. You will want the roof rack by Rhino Rack and…

view full answer...

What Does Pro Series Cargo Carrier Ramp # PS1040200 Look Like Installed

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching