Recommended Anti-Sway Bars for 2010 RoadTrek 190 on Chevy 3500 Chassis

Question

Question:

I have a 2010 roadtrek 190 with a generator mounted behind the rear diff. The vav is a chevy 3500. Im looking to put a sway bar on . I see that there are several to choose from. Can you tell me which one would work for me?

asked by: Joe S

0

Expert Reply:

For your 2010 RoadTrek 190, I recommend the Roadmaster Rear Anti-Sway Bar for Trucks and Motor Homes # RM-1109-175 which is a confirmed fit for your vehicle and should not interfere with your generator. I've attached an installation video to assist, but it does not have the generator in that location. I also recommend the front sway bar # RM-1109-149 which is also confirmed to fit. This combination will work very well for your vehicle and will minimize sway and driver fatigue by improving stability through weight transfer. These bars will also reduce body roll on corners.

expert reply by: Jason S

0

Answer 1

If your motorhome has a generator mounted underneath your veicle behind the rear differential more than likely you are not going to be able to install a sway bar kit like #RM-1109-175-00 due to the generator being mounted where your sway bar would go…

view full answer...

Answer 2

According to my contact at Roadmaster, the Roadmaster Rear Anti-Sway Bar, #RM-1109-150, will fit a Class B motor home built on a Chevrolet Express 3500 Chassis such as your 2006 Pleasure-Way Lexor, but the size and the location of the generator will…

view full answer...

Answer 3

I checked with Roadmaster for you, and verified that there is a rear anti-sway bar that fits your 2021 Thor Freedom Elite on a Chevy 3500 cutaway chassis, though there is not a front anti-sway bar that fits. The correct part number for the rear bar…

view full answer...

Answer 4

According to my contact at Timbren, there is a bolt that holds the bump stop in place from above. Once the bolt is removed, the bump stop you described can be slid out of its slot and removed. As long as the weight bearing capacity of the van is not…

view full answer...

Answer 5

Sounds like the bushings that connect the sway bar to the vehicle's frame may be worn out. With the bushing worn out there will be extra slop and movement in the connection causing the noise when making your turns. I recommend replacing the sway…

view full answer...

Answer 6

The Roadmaster Anti-Sway Bar #RM-1109-175 is a fit for a 2012 GMC Savana or Chevy Express 2500 and 3500 Cut Away Vans of the following body configurations: Class C, EV Type 1, EV Type 3, and the Passenger Cut Away; 4500 Class C and EV Type 1. For…

view full answer...

Answer 7

Both the #RM-1109-175-00 and the #RM-1109-150-00 sway bars are a confirmed fit for your 2004 Chevy Express 3500 Class C Motorhome. The #RM-1109-150-00 is 1-3/8 inch in diameter with a more shallow bump to fit around the rear differential and and the…

view full answer...

Answer 8

I spoke with a Roadmaster technician to verify the correct fit for your 1999 Chevy Roadtrek 200 Popular and found that the Roadmaster Rear Anti-Sway Bar and Axle Mounting Kit #RM-1109-150-00 is the correct fit. The brackets will attach to the outside…

view full answer...

Answer 9

So the Timbren kit part #TGMRG30LB that you referenced is a confirmed fit for your 2003 Chevy Express van but if you were looking for additional support to prevent wallowing and make the van feel more stable and handle better I would highly recommend…

view full answer...

Answer 10

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Answer 11

The old version of the #HBA-CAM used 4 wires, but the product was updated awhile back and now uses only two wires as shown in the photo on the product description page. The white wire from the HBA-CAM would tap into the white ground wire and the blue…

view full answer...

Answer 12

The 40 amp fuse for your 2006 Chevrolet Silverado tow package is used for the 12 volt battery charge circuit. This fuse is located toward the front of the underhood fuse box closest to the front auxiliary positive post (see photo). There may be a…

view full answer...

Recommended Anti-Sway Bars for 2010 RoadTrek 190 on Chevy 3500 Chassis

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching