Wiring Adapter for 2017 Ford Super Duty with Bulb Out Sensors
Question:
I have a 2017 Ford Super Duty. I have installed a truck box mounted deck, sled-deck, atv-deck. The deck has running and brake lights all LED which plug into the trailer wiring outlet via a 4 way flat connector. The wiring only has 3 wires, white, green, brown. When plugged in, all lights work like they should, but the truck thinks there is a turn signal bulb out on the trailer specifically the left. I get the hyper-flash on the dash, but normal flash on the indicators when the turn signal is switched to the left. There is also a little bit of an electrical draw to 2 of the deck lights, they are dimly lit and flicker when all other lights are off. Will this adapter remedy the trailer bulb out sensing of the truck and the dim draw of the lights?
asked by: Kyle A
Expert Reply:
Yes, the 7-Way to 5-Way/4-Way Trailer Adapter # C35FR should correct the hyper-flashing that happens when high-efficiency LED lights are connected to a circuit that is intended for the higher power draw of incandescent lights. This should keep your bulb-out sensors from being a nuisance.
In the event that this adapter does not correct the issue with your deck you can use individual load resistors at each LED light. Examples are part # DI34ZR.
Products Referenced in This Question
Load Resistor Kit for LED Turn Signals - 50 Watts - 6 Ohm - Qty 2
- Accessories and Parts
- Trailer Lights
- Load-Resistor Kit
- Diamond
more information >
Product Page this Question was Asked From
7-Way to 4-Way/5-Way Trailer Adapter for Vehicles with Lamp-Out Sensors Towing Trailers with LEDs
- Trailer Wiring
- Wiring Adapters
- Multi-Function Adapter
- 7 Round - Blade
- Plug Only
- 5 Flat
- 4 Flat
- CURT
more information >
Continue Researching
- Q&A: What Is The Recommended Lug Nut Torque On 7,000lb Axles?
- Shop: Vehicle Tow Bar Wiring
- Search Results: 12x2 electric brakes
- Shop: Hopkins Custom Tail Light Wiring Kit for Towed Vehicles
- Shop: Dexter Electric Trailer Brakes - 12" - Left/Right Hand Assemblies - 6,000 lbs
- Shop: etrailer Electric Trailer Brakes - Self-Adjusting - 12" - Left/Right Hand - 5.2K to 7K
- Shop: Dexter Trailer Hub and Drum Assembly - 5,200-lb E-Z Lube Axles - 12" - 6 on 5-1/2
- Shop: Replacement Turnbuckle for TorkLift Basic SpringLoad Turnbuckle Kit - Qty 1
- Shop: etrailer Electric Trailer Brakes - Self-Adjusting - 10" - Left/Right Hand Assemblies - 3.5K
- Search Results: 25580
- Shop: Trailer Hitch
- Q&A: Lug Nut Torque Chart for Trailer Wheels
- Article: Trailer Wiring Diagrams
- Shop: Trailer Wiring
- Shop: Roadmaster Diode 7-Wire to 6-Wire Flexo-Coil Wiring Kit
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Search Results: 10~36
- Video: Choosing the Right Trailer Wiring
- Q&A: How to Measure to Determine the Size Trailer Brakes Needed For Hydraulic Drum Replacement
- Video: etrailer Electric Trailer Brake Kit Installation
- Search Results: equalizer
- Shop: Base Plate for Tow Bar
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: What is the Best Grease for Trailer Bearings
- Search Results: fender
- Shop: Brake Controller
- Article: Most Popular Wheel Bearings
- Shop: Suspension Enhancement
- Q&A: Common Torque Specifications for Lug Nut Size