Will Westin HDX Grille Guard Interfere with Front Sensors on a 2016 Chevy Tahoe Z71

Question

Question:

I have a Chevy Tahoe 2016 Z71 with sensors will this work on it?

asked by: Peter

0

Expert Reply:

In all likelihood any bull bar or grille guard such as # 57-3805 will interfere with any front mounted sensors on your 2016 Chevy Tahoe. It may be possible to relocate and/or turn off those sensors so if you were to do that then you could use the grille guard without issue.

expert reply by: Michael H

0

Answer 1

The difference between the 10-10 grease seals, #RG06-090, and the 10-36 grease seals, #RG06-070, is their inner diameter. The 10-10 grease seals fit older spindles with a seal journal (see photo) diameter of 2.125 inches. The 10-36 grease seals fit…

view full answer...

Answer 2

There will be modification needed on your 2016 Suburban Z71. The Westin HDX Grille Guard with Punch Plate - Black Powder Coated Steel #57-3805 requires removal of the tow hooks and minor trimming of the tow hook pockets. It will also require removal…

view full answer...

Answer 3

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Answer 4

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 5

For your enclosed trailer application I have several suggestions for adding interior lighting that you can control directly via a switch. Since your current 4-pole trailer wiring does NOT include a 12V auxiliary power feed that could power inside…

view full answer...

Answer 6

The only way you could power interior dome lights on a trailer without it being connected to a tow vehicle would be to power the lights with a battery like a breakaway battery. How you choose to wire up the batteries will in the end be up to you, but…

view full answer...

Answer 7

While we may have an option for you, we do not have the exact specs on your Allis grease seal part number 5013 29772. However, with the 1.6" ID and 2.5" OD measurements you provides, that is very close to our #58846. This particular grease…

view full answer...

Answer 8

I checked your order notes and the leaf springs you bought last year were the part #e28SR which are for 5k axles. Since this is over the capacity of your axle failure would not have been caused by over loading the trailer assuming you stayed under…

view full answer...

Answer 9

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 10

The Dexter 072-078-00 is a 2,200 lb capacity leaf spring. You can use a higher capacity leaf spring, however it won't increase the capacity of your trailer as the axle is still rated for that max capacity of 4,400 lbs. My recommendation for a…

view full answer...

Answer 11

Since Demco uses 3,500 drum brake assemblies part #DMSB24429M and #DMSB24428M what you'd need is similar 3,500 electric brake assemblies like the etrailer part #AKEBRK-35L-SA for the left hand side and #AKEBRK-35R-SA for the right hand side. To…

view full answer...

Answer 12

If you are installing just the Firestone Ride-Rite kit, #F2400, and not also adding an on-board air compressor such as #F2158, then I would estimate that it should take about 2 hours to install the kit. That is for someone with some mechanical…

view full answer...