Can Demco Channel Tongue Trailer Coupler # DM15000-52 be Welded On

Question

Question:

Just wondering if possible to weld instead of bolt on. Seems long enough...

asked by: Lily C

0

Expert Reply:

If you wanted to weld on the Demco Channel Tongue Trailer Coupler # DM15000-52 that you referenced you could. This is powdercoated so you'd need to sand off the powdercoating where you plan to weld.

expert reply by: Jameson C

0

Answer 1

With the Hydrastar Actuators like the #HBA16 the correct brake fluid is DOT 3 or DOT 4. Do not mix the two though.

view full answer...

Answer 2

The Dexter DX7.5L A-60 Brake Actuator w Electric Lockout part #DX29FR for disc brakes and part #DX27FR for drum brakes use 1/2" diameter mounting hardware. We have used both grade 5 and grade 8 bolts when doing installations of them but the…

view full answer...

Answer 3

As long as your Range Rover has a functional 7-way connector with an operational 12-volt accessory lead, the Curt #C51180 Echo Brake Controller will work great for you. As your vehicle is brand new, the 7-way should be wired correctly. Simply mount…

view full answer...

Answer 4

The Trimax Puck Lock for Trailer Door Hasps #TMX96RR cannot be keyed alike. While disappointing I'm sure, there is another option to consider, which is to order a quantity of two of the Trimax Puck Locks for Trailer Door Hasps #TMX73FR. The…

view full answer...

Answer 5

Past customers have told us the AL-KO 8460 uses inner bearing 25580 and outer bearing 15123, which would make the Timken Bearing Kit #TMK82VR the correct replacement bearing kit for that hub. If you are looking to replace the hub entirely the correct…

view full answer...

Answer 6

Yes, I do have the exact dimensions you need of the Demco Channel Tongue Trailer Coupler part #DM15945. I have attached these for you below.

view full answer...

Answer 7

The plunger pins are usually specific to the brand of jack and usually are not interchangeable. Unfortunately, without knowing the manufacturer and model number of your existing jack, I cannot say with certainty that the pin will work for you. I have…

view full answer...

Answer 8

Traditionally, trailer manufacturers did not use electric brakes on boat trailers because the brake magnet wiring and trailer wiring did not always have the best insulation or water protection. These days, more and more manufacturers are using…

view full answer...

Answer 9

I recommend using Grade 5 1/2" x 4" bolts to install the Demco Channel Tongue Trailer Coupler part #DM12717. These would allow for the full weight capacity of the coupler to be achieved. These can be picked up at most local hardware…

view full answer...

Answer 10

I am certainly glad you are taking safety into consideration when trying to choose your coupler, although none of the Demco couplers would be considered "safer" than the others you mentioned. Among the Demco Channel Tongue Trailer Coupler -…

view full answer...

Answer 11

To be able to lock the latch on the Demco Trailer Coupler - Adjustable Channel Mount #DM14976-52 you were looking at I recommend the Bulldog Easy Access Coupler Lock #BD580409.

view full answer...

Answer 12

A pin with a 1/4 inch diameter, like part #e98886, is standard for coupler locks. Unfortunately there are none that are 1/16 of an inch larger in diameter. If instead you meant that you needed one with a span of 5/8 of an inch then you will want to…

view full answer...

Can Demco Channel Tongue Trailer Coupler # DM15000-52 be Welded On

Product Page this Question was Asked From

Continue Researching