Dimensions of Dutton-Lainson Swivel Jack Cap # DL22354

Question

Question:

Is this cap 2 1/4inch in diameter? Part number DL22354

asked by: Peggy

0

Expert Reply:

I went into the warehouse to measure the Replacement Trailer Jack Cap for Dutton-Lainson Jacks # DL22354 for you. The outside diameter of this cap is 1.98 inches and the inside diameter is 1.85 without the rings compressed for tight fit. I've attached a photo to assist.

expert reply by: Jason S

0

Answer 1

The CE Smith Spare Tire Carrier - Locking - Steel - 4-Lug and 5-Lug Wheels - 8-3/4" #CE27202 will fit horizontally as long as your tongue is not more than 3" tall, but I do not recommend it as it will have half of the tire sticking…

view full answer...

Answer 2

We have another Dutton Lainson jack cap that's slightly smaller than what you bought. The part #DL22354 has an outer diameter of 1.98 inches and is most likely what you need based on your picture. Since you are wanting to be extra cautious…

view full answer...

Answer 3

I can tell you that the correct tire size to upgrade from 20.5 x 8 x 10 is going to be 205/65-10. However, the correct wheel is going to depend on what bolt pattern you need. You can use the help article I've linked to determine what bolt…

view full answer...

Answer 4

The tires in your size that we offer have varying pressure ratings depending on their load capacity. For example, if you look at the tires in your size shown on the link I have included you will see that those rated for Load range E, such as…

view full answer...

Answer 5

Carlisle and Kenda trailer tires are about the same in terms of quality. We only sell Kenda currently so I'll try not to give you too much bias...but the Kenda Karrier S-Trail ST145/R12 Radial Trailer Tire #AM10130 that you referenced is very…

view full answer...

Answer 6

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 9

Your math is correct in your trailer weight load example. If a fully-loaded tandem axle trailer weighs 4000-lbs then each of the 4 tires will bear 1/4th of that load, or 1000-lbs. In this case a tire rated for 1300-lbs would provide a good safety…

view full answer...

Answer 10

The three most common lug stud sizes for a trailer are 1/2"-20, 9/16"-18, and 5/8"-18. In order to make sure you get the correct lug nuts you need to measure the lug studs on the trailer now as we have no way to look this up for…

view full answer...

Answer 11

The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6-1/2 inch whereas the 225/75-15 fits widths that are 5 inch to 6 inch. The 205 is 27.1 inches tall and the 225 is 28.4…

view full answer...

Answer 12

The 12 inch tires that we carry are rated for 65 miles per hour. Any faster than that for extended periods and the excessive heat build up will cause tire failure. To get a tire with a higher speed rating you would have to go up in size. That also…

view full answer...

Dimensions of Dutton-Lainson Swivel Jack Cap # DL22354

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching