Dimensions of the Lippert Door Window Frame part # LC363370

Question

Question:

My existing glass size is exactly 21 7/16foot X 12 7/16. Will this fit inside the frame and not end up with a gap at the top or side? Please check the glass retaining stubs in the frame for me. Thanks,

asked by: Gary F

0

Expert Reply:

I attached a picture of the dimensions or the Lippert Door Window Frame part # LC363370 that you referenced. The size you have is the standard that this is designed to fit.

expert reply by: Jameson C

0

click to enlarge

Answer 1

We do not have a window that fits your measurements perfectly, but we do have an option that is close. The Lippert Replacement Window Frame with Seal for RV Entry Doors #LC363370 (black) and #LC363369 (white) includes the frame, glass and seal like…

view full answer...

Answer 2

There are 15-3/4" by 25" RV window door frames with glass, but they do each come with frosted glass, the Valterra Entry Door Window Frame Assembly - Black #A77051, and Lippert Components Replacement Window Frame with Seal for RV Entry Doors…

view full answer...

Answer 3

We have not yet created an installation video for the Valterra Entry Door Window Frame Assembly, #A77051. We do however have a video of similar window frame, from Lippert, #LC363370 being installed as replacement.

view full answer...

Answer 4

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

You are correct that this refrigerator does not have an ON/OFF switch or function. The best you can do is "Standby" that draws an unknown amount of power. One option is to pull the 12-Volt fuse at the RV power center. A much better option…

view full answer...

Answer 10

We do carry the Dometic RV Water Heater #DMC74FR which you could use to replace your Atwood G6A-8E 6 gal RV Water Heater, but I highly recommend switching over to a tankless system like the Furrion RV Tankless Water Heater 60,000 BTU #FR98SR. This…

view full answer...

Answer 11

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…

view full answer...

Answer 12

A BT8 spindle would have a diameter of .99 of an inch where the bearings would both install and would have a diameter of 1.24 where the great seal would ride. That would require a hub part #AKIHUB-440-2-1K for an idler hub. A BTR spindle would have…

view full answer...

Dimensions of the Lippert Door Window Frame part # LC363370

Product Page this Question was Asked From

Continue Researching