Mounting Bolt Pattern for the Valterra Bladex Waste Valve Body
Question:
I want to be sure this 1 1/2 valve will replace the Valterra valve on my 1990 Terry camper. My old part has a 2 7/16inch bolt pattern and want to be sure this new part has the same bolt pattern for the four holes. Can you confirm please.
asked by: Steve
0
Expert Reply:
Sounds like the part # T1001VP would fit as a replacement but you might want to remeasure. This valve has mounting holes that are 2-1/2 inches square.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Valterra Bladex Waste Valve Body for RV Gray Water Tank - Plastic Handle - 1-1/2" Diameter
- RV Waste Valves
- Straight Valve
- Single Waste Valve - Manual
- 1-1/2 Inch Valve Body
- Stationary Valve
- Valterra
more information >
Continue Researching
- Q&A: Best 5th Wheel Hitch for 2018 Ram 2500 with Factory Puck System
- Q&A: Dimensions Of Valterra RV Waste Valve
- Article: How to Install E-Track in 3 Easy Steps
- Q&A: Horst Miracle Probes for Gray and Black Water Tanks
- Q&A: Replacement Sewer Wye for Bristol V33B2R on Cobra Salem RV
- Q&A: Correct Replacement for Dexter Trailer Brake Assemblies 023-466-00 and 023-467-00
- Q&A: Replacement for Shurflo 2088-422-174 Fresh Water Pump
- Q&A: Determining The Correct Replacement Entry Lock For A 2008 Fleetwood Bounder 38V
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: 2 Steps for Hooking Up an External Propane Tank to Your RV
- Article: Flat Towing Package for 2007 Honda CR-V
- Article: Keep Your Daydream
- Article: Our Team Picked The Best Camping Gear of the Year - Here Are Their Top Choices
- Article: Wiring Trailer Lights with a 6-Way Plug (It's Easier Than You Think)