Availability of Torx Self-Tapping Screw for Exterior Panels of Haulmark Enclosed Trailer

Question

Question:

Hello, I have a 14 Haulmark enclosed trailer and I am trying to match up the screws that are holding the aluminum exterior together. They are a torx head, about 1 1/4inch long, self tapping, pan head. The tip seems to be somewhere between T15 and T20 but I am not certain since I dont seem to have anymore of tips at the moment. Can you help me find these screws? Do you know the ones I am talking aobut? Your help is appreciated thank you.

asked by: Chris

0

Expert Reply:

The closest we have to what you need is the part # WLS100 which is a 1 inch long Torx screw with the self-tapping head.

expert reply by: Jameson C

0

Answer 1

Catalytic heaters like the #CAM57331 Wave 3 do indeed put out moisture as a byproduct of the heating process, it's unavoidable with that type of heater. After doing some research, I've found that the best bet to keeping a large part…

view full answer...

Answer 2

The B&W Turnoverball Underbed Gooseneck Trailer Hitch w/ Custom Installation Kit - 30,000 lbs item #BWGNRK1020 does not require the bed to be removed when it is installed on your 2022 GMC Sierra 3500. I have linked the instructions and an…

view full answer...

Answer 3

The 1" Long Black Torx Wall Liner Screw #WLS100 is the best option for the plywood installation. These screws are fine thread and made for metal studs. They have a tapping edge but often a starter or pilot hole should be drilled. You can then…

view full answer...

Answer 4

After a few moments of looking over the instructions provided by Firestone and comparing them to the video, I realized that in the printed instructions, the connections to the relay are not shown which is what is leading to your confusion. There are…

view full answer...

Answer 5

That is going to depend on the thickness of the floor on your cargo trailer. I attached a link to a page that has all of the self tapping screws you could use for E-tracks. You will want to select the length you need from the filters on the page and…

view full answer...

Answer 6

The 7,200 lb Dexter hub is the part #8-393-4UC3 which takes the grease seal part #10-63.

view full answer...

Answer 7

I spoke to Dexter and they said there is a bit of a process for installing the spindle nut properly. 1. You will need to thread on the inner nut, rotate the hub, then tighten the nut to 100 foot pounds. 2. Loosen the nut to remove the torque, making…

view full answer...

Answer 8

The Ram Trailer Jacks generally use a 1" diameter threaded rod whereas the Bulldog Trailer Jacks generally use a 1-1/4" threaded rod. Therefore, it would appear as if you have a Bulldog Trailer Jack and in which case the Replacement Screw…

view full answer...

Answer 9

I produced a short video showing how the Wire Frame Clip works on a piece of angle iron. The Principal is the same on a trailer frame and the clip will adhere better to the frame of the trailer because the steel will be thicker. It clips to the…

view full answer...