Mounting Hole Size and Spacing on Mighty Cord Replacement 30-Amp RV Power Inlet A10-30INBKVP

Question

Question:

what are the mounting hole sizes and center -distances on this item ? thanks

asked by: Lee M

1

Helpful Expert Reply:

I went to our warehouse and measured the Mighty Cord Replacement 30-Amp RV Power Inlet # A10-30INBKVP and found its four mounting holes are 1/8-inch diameter and they are spaced apart 2-7/16-inches on center.

expert reply by: Adam R

1

Answer 1

I do have a simple wiring diagram for the Progressive Dynamics Inteli-Power RV Converter and Smart Battery Charger - 12V - 45 Amps #PD9245C. Basically you just need to run the power wire from the converter directly to the DC distribution panel and…

view full answer...

Answer 2

The main AC breakers of the #PD4135K should be 30 amp. As far as wiring we have to recommend you stick with Progressive Dynamics and consult a licensed electrician or RV tech for the wiring and install of the kit. On the panel with the fuses the left…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

Hey Michael, thanks for reaching out! The EcoHitch #EH57FR sits a little higher than the Curt #C52NR so it will give you better ground clearance for your 2024 Chevy Silverado 2500. The EcoHitch is a bit more recessed into the front bumper than the…

view full answer...

Answer 7

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 8

Some newer cars, vans and small trucks, especially those with large, aftermarket tires, may require the use of Class S chains. Class S tire chains are designed for use on vehicles with restricted wheel well clearance. I have attached a photo that…

view full answer...

Answer 9

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 10

Trailer wheel bearings are specific to the spindle that is installed on the axle that is on your trailer. You will need to safely support the trailer, remove the wheel and tire, remove the grease cap, remove the cotter pin and washer that secures the…

view full answer...

Answer 11

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 12

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Mounting Hole Size and Spacing on Mighty Cord Replacement 30-Amp RV Power Inlet A10-30INBKVP

Product Page this Question was Asked From

Continue Researching