Can Power Cables of Power Grip RV Power Maximizer # CAM55025 be Ran to Generator and Wall Outlet

Question

Question:

Can I hookup the 30amp adapter to my portable generator and then the 15amp adapter to my house line 20 amp circuit to run 45+ amps? Basically to run it a few hours when Im cleaning up the rig at homelike to run both A/C Units. My rigs power unit is a 50amp cord.

asked by: Bob

0

Expert Reply:

Yes, what you described would be perfectly acceptable. Run the 30 amp to the generator and then the 15 to your shore power and then that would work just fine with your RV's 50 amp socket.

expert reply by: Jameson C

0

Answer 1

We do have a number of wiring adapters that will allow connecting 50 amp devices to a 30 amp outlet at an RV park. You are correct though that plugging your 50 amp RV into a 30 amp power source will likely limit the amount of appliances you can have…

view full answer...

Answer 2

Yes, the Camco Power Grip #CAM55025 will work if you plug in both the 30 amp male and 15 amp male into your generator.

view full answer...

Answer 3

The Power Grip RV Power Maximizer #CAM55025 that you referenced will plug into the 30 amp receptacle as well as a 15 amp receptacle and will give you a combined 45 amp on a 50 amp power plug. I wish we had a version that gave you a 30 amp plug like…

view full answer...

Answer 4

The quick-connect fittings that come with the Valterra EZ Coil-N-Store Drinking Water Hose #W01-0022 are only available through Valterra as a whole kit, but you should also be able to find some at your local hardware/home improvement store that will…

view full answer...

Answer 5

You do NOT have to plug in both the 15-amp and 30-amp male ends to use the Power Grip RV Power Maximizer #CAM55025. You can plug in just the 15-amp or just the 30-amp male end and it will still work. The 30 or 15 amp end not plugged in will NOT be…

view full answer...

Answer 6

Yes the configuration you mentioned would work fine with the Power Grip RV Power Maximizer #CAM55025. You can plug the 15 amp plug into a generator and the 30 amp into a power outlet and you'd be totally fine.

view full answer...

Answer 7

Based on the connectors I see on the side of your generator the Power Grip RV Power Maximizer - 50 Amp Female to 15 Amp Male and 30 Amp Male #CAM55025 will work to combine to a 50 amp connector. An AC unit that is rated for 8,000 BTU draws up to…

view full answer...

Answer 8

Unfortunately we do not carry the adapter you are looking for, but I do have another option for you. My recommendation is to use a Power Grip RV Power Maximizer - 50 Amp Female to 15 Amp Male and 30 Amp Male #CAM55025 to get a generator to give you…

view full answer...

Answer 9

The Power Grip RV Power Maximizer - 50 Amp Female to 15 Amp Male and 30 Amp Male #CAM55025 has independent wiring connected to the 50 amp Female end. When you plug in the 30 amp male, there will not be 30 amps of power going to the smaller 3 prong…

view full answer...

Answer 10

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Answer 11

Yes, you are correct. In order to correctly take this measurement you will need to measure from the center of the spindle to the center of the main axle tube. I have included a picture for reference.

view full answer...

Answer 12

The DeeMaxx item #DE86VR won't because of the spacing on the mounting bracket but I have a caliper that will. To replace your Tie Down Engineering 46304 caliper you will need the Kodiak Disc Brake Caliper item #KDBC225DAC.

view full answer...

Can Power Cables of Power Grip RV Power Maximizer # CAM55025 be Ran to Generator and Wall Outlet

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching