What Kind of Metal is the Rack em Fitz-All Enclosed Trailer Ladder Rack # RA-28 Made Of

Question

Question:

Are these Alluminum?

asked by: Sean

0

Expert Reply:

Yes, this Rack em Fitz-All Enclosed Trailer Ladder Rack, part # RA-28, is made of aluminum and uses stainless steel screws.

You may also be interested in purchasing Rack em Load Stop for Ladder Rack, part # RA-28-S.

I attached installation instructions for the # RA-28 below for you to check out also.

expert reply by: Jameson C

0

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

Hey Kevin thanks for your question. There is not much downside to going with the 5,000 lb springs instead of the 3,500 lb. A higher rated spring may make the ride a bit more "chunky" at times, since the spring would not flex as easily.…

view full answer...

Answer 5

Hey Jaime, yes you can replace your 25-1/4 inch 3,500 lb axle leaf springs with a 5k rated axle spring like the part #e44SR. This will increase the suspension's weight capacity and might make the ride quality a little rougher but it would fit and…

view full answer...

Answer 6

Hey Jim! The Taskmaster and Westlake tires, like the Taskmaster ST235/75R15 Off-Road #TA45RR and Westlake ST235/75R15 Off-Road #WST54FR you were looking at, are made in China. A lot of people tend to shy away from trailer tires made in China but…

view full answer...

Answer 7

The weight capacity for Rackem Fitz-All Enclosed Trailer Ladder Rack part #RA-28 at a 7 ft width is 400 pounds. These racks are designed for fiberglass ladders, if you need more capacity another set can be added to spread the weight out more.

view full answer...

Answer 8

I called my contact at RackEm and asked about the Fitz-All Enclosed Trailer Ladder Rack, part #RA-28 and your all aluminum trailer. They told me that two sets would be ideal for your trailer since it is 12-ft long and the load capacity would be…

view full answer...

Answer 9

Yes, for 5,200 standard trailer axles we have the hub part #8-219-4UC3-EZ which is a fit for 5,200 lb axles and has the bolt pattern of 8 on 6-1/2 inches like you said you need.

view full answer...

Answer 10

The weight capacity for the Rackem Trailer Cargo Control, part #RA-28 is listed at 400 lbs. This is the weight capacity for the complete rack, and not just one bar. When installing you need to make sure you have a solid place to secure the mounting…

view full answer...

What Kind of Metal is the Rack em Fitz-All Enclosed Trailer Ladder Rack # RA-28 Made Of

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching