What Are The Different Types Of Quick Disconnect Flare Fittings For Propane Tanks

Question

Question:

Are all the gas quick fittings the same standard design? I see the male Sturgis is $3+ and the Camco male is $11-12. Will the Sturgis male snap into my Camco female coupling.

asked by: Sonny

0

Expert Reply:

The quick disconnect fittings are the same and is an industry standard.

The difference between the Camco Quick-Connect Full Flow Plug for Low Pressure Propane Systems part # CAM59903 and the MB Sturgis Quick Disconnect Propane Adapter Fitting part # 401132-MBS is as follows.

Like many other instances, the reputation and popularity of the manufacturer will largely affect the product's price.

expert reply by: Conner L

0

Answer 1

I checked with Curt and you are correct, the flashing red light indicates a brake circuit overload. Since the light is flashing that most likely means you have a short somewhere on the brake output circuit drawing too much power. To correct this…

view full answer...

Answer 2

On the Curt Venturer brake controller #C74VV, if the red dot is solid that indicates that the trailer is not connected, or at least the brake controller is sensing a disconnected condition. This seems like what is going on. When the trailer jerks…

view full answer...

Answer 3

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 4

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 5

Great question, Jeff! When the Rota-Flex first came out it renovated what a pin box could do and be, but at this point in time that technology is a little more dated and the Gen-Y Hitch Shock Absorbing 5th Wheel Pin Box #325-GH-8040 is the "new…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

The head alone for the B&W Companion hitch #BWRVK3500 weighs about 70 pounds. Everything else weighs about 130 pounds. So the total weight of the hitch is approximately 200 pounds.

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

If you take a look at the linked diagram you can see the minimum recommended clearance distances between truck and trailer for 5th wheel towing. It is recommended to have at least 5-inches from the top of the bed rails to the bottom of the trailer…

view full answer...

What Are The Different Types Of Quick Disconnect Flare Fittings For Propane Tanks

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching