Does Tire and Wheel on Tow Dolly Need to be Balanced

Question

Question:

Hello. Going to order tires st205/7514 from you. However will need to get them mounted here. They are going on Demco Tow Dolly. Do they need to be balanced? Thanks

asked by: Randy

0

Expert Reply:

What tire mounters will do with trailer wheels and tires is line up the light spot on the tire with the heavy spot on the wheel. This is a type of balancing but not like how car tires are balanced (with weights on a balancing machine).

You can have yours balanced if you want but you most likely wouldn't feel the difference.

In your tire size of 205/75-14 I would go with the part # 274-000012 as it's a radial which means it will ride better and it as a 75 speed rating which is higher than most trailer tires which are only rated for 65 mph.

expert reply by: Jameson C

0

Answer 1

Long story short, yes you can. But going with the ST205/75R14 would be a better replacement than a ST205/75D14 because the R in the first size means it is a radial tire whereas the D in the second size means it is a bias ply. The main difference…

view full answer...

Answer 2

That is an awkward size, I have not heard of a bolt pattern of 5 on 4-5/8. I would recommend measuring from the center of one bolt hole to the center of an adjacent bolt hole and use that measurement to determine your bolt pattern. If this…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 5

Since both a ST145/R12 size tire, like the Kenda Karrier S-Trail #AM10130, and a 5.30-12 size tire, like the Kenda K353 #AM10068, fit a 12 inch wheel, a ST145/R12 size tire can replace a 5.30-12 size tire. Keep in mind that these tires do have…

view full answer...

Answer 6

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 9

Your math is correct in your trailer weight load example. If a fully-loaded tandem axle trailer weighs 4000-lbs then each of the 4 tires will bear 1/4th of that load, or 1000-lbs. In this case a tire rated for 1300-lbs would provide a good safety…

view full answer...

Answer 10

Tire designations ST205/75D14 and ST205/75R14 are both for special trailer tires with a 205mm width, 75-percent aspect ratio and that fit a 14-inch wheel. The difference between them is the tire's type of construction. The ST205/75D14 tire is a…

view full answer...

Answer 11

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 12

The difference between the two trailer tire sizes is that the letter D in the first size you listed ST205/75D15 stands for bias ply and the letter R in the tire size that they put on your vehicle stands for radial. Radial tires are preferred over…

view full answer...

Does Tire and Wheel on Tow Dolly Need to be Balanced

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching