What is the Height of the Battery Box Vented, part # DW03188

Question

Question:

The external dimensions are listed as 10 1/2 x 7 3/8 x 9 1/4. Can you please tell me which one is the height of the box.

asked by: Ed H

0

Expert Reply:

The height dimension of this Battery Box, part # DW03188, is 9-1/4 inches.

The length is 10-1/2 inches and the width is 7-3/8 inches.

expert reply by: Jameson C

0

Answer 1

There is not a Group 26 battery box for some reason. The smallest battery box available that will fit your 9" L x 6-1/2" W x 8-1/2" H battery is the Tow-Rax Battery Box #TWSP12B. This measures 12" long x 8-7/8" wide x…

view full answer...

Answer 2

I just spoke with my rep at Timbren. The height of the Timbren Suspension Enhancement System - Rear Axle Item #T62FR for your 2010 Toyota Tundra is 3 9/16 inches for the rubber spring portion and 1 5/16 inches for the bracket with a combined overall…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

It is possible to use a 7-way vehicle end connector such as #PK12-707E to hook up to a stand-alone battery for your lights. You would need to connect by using 10 gauge wire, #10-2-1, and if you use a deep cell battery as you suggested, a pair of ring…

view full answer...

Answer 5

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 6

I had our warehouse measure the Fulton XLT Powered Drive Trailer Jack #F141401 you were looking at and it has the following measurements. From top of mounting bracket to top of head assembly is 21", from the front to the back of the head…

view full answer...

Answer 7

The leg length or the depth that the garnish part #2756 has is right at 2 inches. From the picture you submitted it looks like you installed the roof vent part #9106 with the mounting flange on the inside of the trailer. The vent should be installed…

view full answer...

Answer 8

The Solera 12V Power RV Awning Conversion Kit #LC434724 that you referenced would work great as a replacement for the Carefree Fiesta manual arms you have now. This will make extending and retracting your awning much easier. I attached a review video…

view full answer...

Answer 9

You cannot put RV batteries, marine batteries, and other deep cycle batteries away and forget about them when you’re not using them in the winter. All batteries can freeze if it gets cold enough, but AGM batteries can work at temperatures well below…

view full answer...

Answer 10

Yes, the RetraxONE XR Hard Tonneau Cover w/ Trax Rails #RTT-60752 that you referenced is compatible with your 2016 Nissan Titan XD 6-1/2 foot bed that has the utili tracks and the Titan boxes!

view full answer...

Answer 11

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

What is the Height of the Battery Box Vented, part # DW03188

Product Page this Question was Asked From

Continue Researching