Will The Pro Series Round A-Frame Jack Be Compatible With the Atwood A-Frame Coupler 2-5/16 Ball?
Question:
Is the bolt pattern on the Pro Series Round, A-Frame Jack w/ Removable Footplate - Topwind - 14inch Lift - 2,000 lbs - PSEA2000-14007 compatible with the Atwood A-Frame Trailer Coupler - Thumb Latch - 2-5/16inch Ball - Weld On - 10,000 lbs - 81911?
asked by: Alan L
0
Expert Reply:
The Atwood A-Frame Trailer Coupler has a standard jack mount setup, so the Pro Series Round, A-Frame Jack w/ Removable Footplate - Topwind - 14" Lift - 2,000 lbs # PSEA2000-14007 will be compatible.
expert reply by:
Jason S
0
Product Page this Question was Asked From
Pro Series Round, A-Frame Jack w/ Removable Footplate - Topwind - 14" Lift - 2,000 lbs
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Utility Trailer
- A-Frame Jack
- Leveling Jacks
- Tongue Jacks
- Steel
- 1001 - 2000 lbs
- Topwind Jack
- 14 Inch Lift
- Bolt-On
- Weld-On
- With Rectangle Foot
- Pro Series
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Article: How to Choose a Battery Charger
- Q&A: Troubleshooting Rear Brakes on a 2022 Montana High Country 5TH Wheel Locking Up
- Q&A: Determining the Best Top and Side Trim Options for an Enclosed Trailer
- Q&A: What Does Working Load Limit Mean for E-Track
- Q&A: What is the Working Load Limit for the E-Track System
- Q&A: Will Stromberg Carlson Electric Trailer Jack # JET-5000 Fit Jack with 3 inch Bolt Pattern
- Q&A: 2 inch Outer Diameter A-Frame Trailer Jack Recommendation
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Q&A: How To Install The Advent Air RV Air Conditioner System With ACTH12 Thermostat
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: Trailer Jacks
- Article: What To Look For When Buying Ratchet Straps