Will The Longview Custom Towing Mirrors # CTM1600 Fit A 2011 Chevrolet 2500 Crew Cab 4x4

Question

Question:

Will these fit my 2011 Chevy 2500 Crew Cab 4x4? If these dont fit, could you give me some part numbers that would? Thanks

asked by: Dean N

0

Expert Reply:

The Longview Custom Towing Mirrors, part # CTM1600, will fit your 2011 Chevrolet Silverado 2500 Crew Cab 4x4. The custom mirrors would slide over your existing mirror. There is a hook that attaches to the front of the existing mirror housing and wraps around the side of the mirror. The other end of the hook passes through a hole in the slip on mirror and is tightened by a knob that threads onto the end of the hook.

If your 2011 Chevrolet 2500 Crew Cab does not have the telescopic mirrors you can also use the CIPA Original Custom Towing Mirror Slide-On Mirrors, part # 10901 and # 10902. These mirrors will also slide over your factory mirrors.

expert reply by: Jeff D

0

Answer 1

Since the issue appears to be on the vehicle side for your 2017 Toyota Tacoma, I recommend first checking the connector itself. Look to see if there is any dirt or corrosion built up inside the connector that may preventing a solid connection with…

view full answer...

Answer 2

In terms of capacity, the Timbren Rear Suspension Enhancement System, #TGMRG25C, for a 2003 Chevy Avalanche 1500 has quite a bit more; a total capacity of 6,000 pounds. Compare that to the maximum 1,000 pound capacity of the Firestone Vehicle…

view full answer...

Answer 3

If you sever the blue wire leaving the P3 controller part #90195 leaving enough room to reconnect it and test the end of the wire leaving the controller with a circuit tester like part #PTW2993 you should see voltage when you slide the manual…

view full answer...

Answer 4

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 5

The Longview Towing Mirrors, part #CTM1600 are fully adjustable. Typically, the OE mirrors on a vehicle drivers side are flat and the passenger side is convex. According to Longview Mirror, the driver and passenger side slide on towing mirrors are…

view full answer...

Answer 6

The dimensions for the RC Manufacturing Trailer Tongue Box are; width at back is 36 inches, width at front is 21-1/2 inches, the height of the box is 20 inches and the depth of the box is 16 inches. You can see these dimensions in the photo I have…

view full answer...

Answer 7

For your 2018 Cadillac Escalade the Timbren Rear Suspension Enhancement System #TGMRYS4 will work great. These jounce-style springs are confirmed to fit your vehicle and will simply replace the factory bump stop on the frame to provide additional…

view full answer...

Answer 8

What I recommend is going with the Timbren vehicle suspension #TGMRYS4 (2WD or 4WD)because the hollow rubber springs sit above the axle and they are easy to install. It will also be compatible with your auto-leveling system. Also, the Timbren…

view full answer...

Will The Longview Custom Towing Mirrors # CTM1600 Fit A 2011 Chevrolet 2500 Crew Cab 4x4

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching