How to Install a Brake Controller on a 2012 Ford E-350 Van w/o Factory Trailer Connection
Question:
Does this part work for a van that did not have a factory prewired harness? I have had to wire up the electrical for a trailer hitch in the back. I need to add a brake controller so I bought the tekonsha one but I would like to do it without having to hardwire it in. I would think this part #3034-p would be helpful but If I plug it into my van, how to i make sure the blue wire for break modulation runs back to my 7-pin connector in the back? Am I missing something? Let me know. Thanks. Dave
asked by: Dave F
Expert Reply:
I have a solution for you, but on your model 2012 Ford Van the brake controller will have to be hardwired to the van.
If you already have installed 7-way, then a blue wire must be run from the 7-way up to the cab of the truck to connect to your brake controller. I recommend using # 10-1-1 for the brake circuit wiring. I also recommend # 12-1-1 wiring when connecting to the stop light switch on your van. This wire is sold by the foot.
I also recommend using # 5506 Wiring Kit for Brake Controller. This kit will include a duplex wire to run both 12-volt power and a ground to your brake controller, This kit also will include circuit breakers and connectors to complete the job.
I have attached an article and a diagram the will help you with your installation of the controller.
Products Referenced in This Question
Wiring Kit for 2, 4, 6, and 8 Brake Electric Trailer Brake Controllers
- Accessories and Parts
- Trailer Brake Controller
- Installation Kits
- etrailer
more information >
Product Page this Question was Asked From
Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers - Ford
- Accessories and Parts
- Trailer Brake Controller
- Wiring Adapter
- Plugs into Brake Controller
- Vehicle Specific
- Tekonsha
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: How to Charge a Dump Trailer Battery
- Q&A: Recommended Lithium Battery Compatible Power Converter For Parallax 7355
- Q&A: Recommended Components for Off-Road Trailer Similar to Chevy Colorado Wheels
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Replacement Arms for Roadmaster EZ5 Base Plate Kit for 2015 Honda Fit
- Q&A: Recommended Replacement For A WFCO WF-8750P Power Center
- Q&A: Is the Progressive Dynamics Lithium Converter PD4655LIV An Upgrade for the Parallax 7355
- Q&A: Replacing Parallex 7345 Converter to One that is Compatible with Lithium Batteries
- Q&A: Is There Down Side to Progressive Dynamics 4000 Series 60 Amp Over 45 Amp
- Article: Trailer Hitch Receiver Sizes
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: Cleaning Your RV Black Water Tank in 4 Easy Steps
- Article: What is Boondocking
- Article: Trailer Wiring Diagrams