Hitch Lock Recommendation for a BikeWing Bike Rack on a 2017 Chevy Bolt EV

Question

Question:

I purchased a Draw-Tite Sportframe Trailer Hitch Receiver for a 2017 Chevy Bolt EV part #24956. The features list says Drawbar, pin and clip sold separately. What else do I need to purchase if I want to lock my bike rack to the receiver and keep it from moving/rattling? Thanks.

asked by: Takashi O

0

Expert Reply:

The drawbar would only be used if you were towing a trailer and the 2017 Chevy Bolt EV is not rated for towing so you would not need the drawbar.

I checked your order notes and it looks like you ordered the BikeWing (Discontinued) LGA54FR. This rack has a threaded hitch pin which provides anti-rattle abilities. To lock it you can use padlock # 131D through the hole at the end of the threaded hitch pin.

expert reply by: Michael H

0

Answer 1

The hitch I recommend for your 2018 Chevy Bolt EV for carrying a bike rack is the Draw Tite #24956 because it has the highest capacities, has a concealed crosstube, and unlike the Curt hitch for your vehicle it does not require the use of a…

view full answer...

Answer 2

Thanks for passing that on! I am posting this on our site with your pictures to other owners of the 2022 Chevy Bolt EV that the Draw Tite hitch part #24956 does fit!

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 7

The CE Smith Multi Sport Plus Boat and Kayak Trailer w/ Bunks #CE48870 that you referenced was designed to be used with boats that are up to 14 feet in length like what you have now. I attached a picture that shows the range of where the winch…

view full answer...

Answer 8

Yes, the CE Smith Multi Sport Plus Boat and Kayak Trailer w/ Bunks #CE48870 does come pre-greased. You will want to grease the hubs approximately every 12 months or 12,000 miles.

view full answer...

Answer 9

We have the CE Smith boat trailer part #CE48810 which is designed for small boats like your 12.5 foot Flycraft inflatable boat. I attached a picture that shows a similar boat loaded on this trailer as well.

view full answer...

Answer 10

You actually do not want the weight of the load on a trailer to balance perfectly on either side of the axle. You want more weight forward so that the trailer doesn't sway. What you'll want is 10-15 percent of the total trailer weight as…

view full answer...

Answer 11

The overall width of the CE Smith Multi Sport Plus Boat Trailer with Bunks #CE48870 is 54 inches wide.

view full answer...

Answer 12

Once assembled, the CE Smith #CE48870 Multi-Sport Plus Boat and Kayak Trailer weighs right at 200 lbs, there might be some confusion on this though since the shipping weight is quite a bit more due to the amount of packaging required.

view full answer...