Which Bolts of Fastway Weight Distribution System are Used for Setting Angle of System
Question:
FA94-00-0600 Fastway e2 Weight Distribution w/ 2-Point Sway Control - Round - 6,000 lbs GTW, 600 lbs TW I put this product together. There are 6 washers that I assume go to the bolt on the car ball hitch at the bottom. The bolt controls the angle of the ball. The washers do not fit over the bolt at the bottom. I watched the factory video. He said he was putting 4 washers on but the video skipped him doing it. I can only assume the washers go on the bottom adjusting bolt. Either the washers included are the wrong size, or Im not using the right, or they go elsewhere. Thank you
asked by: Richard F
Expert Reply:
The smaller washers of the Fastway kit part # FA94-00-0600 you referenced are for controlling the angle of the head.
The bolt you should be using is the 5/8 inch angled set bolt.
I attached a diagram I took from the instructions that show how all the pieces go together.
Product Page this Question was Asked From
Fastway e2 Weight Distribution w/ 2-Point Sway Control - Round - 6,000 lbs GTW, 600 lbs TW
- Weight Distribution Hitch
- WD With Sway Control
- Some Sway
- Includes Shank
- Electric Brake Compatible
- Surge Brake Compatible
- Fits 2 Inch Hitch
- Allows Backing Up
- 500 lbs
- Fastway
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Suspension Enhancement
- Shop: Trailer Hitch
- Shop: Towing Mirrors
- Article: How to Install a Weight Distribution Hitch (With Pictures & Video)
- Shop: Replacement L-Pin Clip for Fastway e2 Weight Distribution Systems
- Shop: Trailer Wiring
- Shop: Timbren 1" Spacer For Raised Frame Vehicles - 3/8" Bushing
- Shop: Timbren Suspension Enhancement System - Severe Service - Rear Axle
- Shop: Timbren Rear Suspension Enhancement System
- Shop: Timbren 1/2" Spacer for Raised Frame Vehicles
- Shop: K-Source Snap & Zap Custom Towing Mirrors - Snap On - Driver and Passenger Side
- Q&A: Why is it Important to Make Weight Distribution Head Angle Adjustment
- Q&A: Which 1 inch Lift Spacer to Use with Timbren Suspension Kit TFR1504E
- Q&A: How To Reduce Rear Sag With Equal-i-zer Weight Distribution System and 2019 Ford F-150
- Video: Timbren Rear Suspension Enhancement System Installation - 2019 Ford F-150
- Video: Timbren Rear Suspension Enhancement System Installation - 2017 Ford F-150
- Video: Timbren Rear Suspension Enhancement System Review RU-18-TA-00302588
- Video: Fastway e2 Weight Distribution System Review
- Article: How to Choose the Right Trailer Hitch Class
- Video: Choosing the Right Trailer Wiring
- Search Results: hitch
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Shop: etrailer Hitch Pin Alignment Collar for Hitch Accessories - 2" Hitches
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Search Results: trailer hitch
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Shop: Brake Controller
- Search Results: air bags
- Video: Choosing the Right Brake Controller
- Q&A: Best Way to Prevent Sagging Suspension When Towing a Trailer