Recommended Weight Distribution System with a 2017 Ram 1500

Question

Question:

Good morning I am looking for recommendations for a weight distribution hitch for my 2017 ram 1500 I am towing a 16ft open car trailer with a jeep wrangler around 7500-8k max which would you suggest. Thank you in advance!

asked by: Stephen

0

Expert Reply:

To choose the correct weight distribution system you'll need to find your total tongue weight. This is your trailer's loaded and ready to tow tongue weight added to the amount of weight stored behind the 2016 Ram 1500's rear axle. You want the total tongue weight to fall somewhere in the middle of what the system is rated for.

With a trailer between 7,500 and 8,000 pounds you'll likely need a system rated for 1,000 pounds of tongue weight. If this ends up correct I suggest the Reese Steadi-Flex # RP66559. It uses friction pads similar to automotive brake pads for sway control. If your total tongue weight is over 1,000 pounds you can go with the # RP66560 rated up to 1,200 pounds.

Both systems will also need a hitch ball. Use # 19286 for a 2-5/16 inch ball or # A-90 for a 2 inch.

expert reply by: Charles S

0

Answer 1

As long as the Air Lift LoadLifter 5000 Air Springs #AL57375 is properly installed on your 2021 Ram 1500 the airbags will not void your warranty. You are protected under the Magnuson–Moss Warranty Act which states that manufactures cannot void the…

view full answer...

Answer 2

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 5

If you are considering Timbrens like the #TDR1500DQ and the SumoSprings like the #SSR-307-47 for your 2022 Ram 1500 4x4, I recommend the SumoSprings #SSR-307-47. The SumoSprings will offer the same quality as the Timbrens in terms of suspension…

view full answer...

Answer 6

Hi Jeff; thanks for the question and sturdy is definitely a good word for the etrailer tonneau that fits your 2022 Ram 1500 with a 5-1/2 foot bed, the etrailer Hard Tonneau Cover #e35DR. It's made of a fiberglass-reinforced plastic which is a…

view full answer...

Answer 7

Thanks for reaching out, Scott! The Blue Ox Base Plate Kit #BLU74FR on our site is actually the same thing as the Blue Ox part number BX2418 and I like that removable pin style much more than the etrailer Classic Base Plate Kit #e98945 with the fixed…

view full answer...

Answer 8

The Dometic RV Water Heater - Gas - Automatic Pilot - 12 Volt - 8,800 Btu - 6 Gal Tank Item AT96121 is the direct replacement for the GC6AA-10E. Unfortunately it is out of stock with no expected restock date. Instead I recommend the Furrion RV…

view full answer...

Answer 9

The correct Roadactive kit that fits your 2023 Ford F-150 is the part #RAS3611-YHD. I really like the RAS kits as they basically don't have any downsides. You get the adjustable support, an easy install, no maintenance, and actually improves…

view full answer...

Answer 10

According to RoadActive Suspension the spring rate for the standard kit #RAS3611-S is 2,400 lbs. For the heavy duty #RAS3611-SHD it is 3,600 lbs. The heavy duty #RAS3611-SLHD is the same but only designed to fit if you have factory top overload…

view full answer...

Answer 11

It is possible to use a weight distribution system and air spring suspension enhancement together in a 2013 Ford F-250 or F-350 Super Duty, though if you are experiencing sag with a weight distribution system, it may not have the proper rating for…

view full answer...

Answer 12

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...