Replacement Spring Bar for Fastway E2 Weight Distribution System 600 lbs Tongue Weight

Question

Question:

I need a replacement Round Bar for an EZ trailer hitch kit. The number is 94-00-0600. I didnt see it on your website. Can you help? ThANKS

asked by: Thomas M

0

Expert Reply:

For a single replacement 600 lb spring bar for the Fastway E2 WD kit part # FA94-00-0600 you would want the part # FA94-02-0699.

expert reply by: Jameson C

0

Answer 1

If you were to upgrade to the 800 Lb Replacement Round Spring Bar part #FA94-02-0899 on your Fastway e2 Weight Distribution part #FA94-00-0600 then you would need to readjust the head tilt mechanism. There would likely be a different amount of…

view full answer...

Answer 2

You can swap just the spring bars of your Fastway Round Bar Weight distribution system to a higher rated setup. For that we have the part #FA94-02-1099 for 1,000 lb tongue weight or the part #FA94-02-0899 for up to 800 lb tongue weight.

view full answer...

Answer 3

If the loaded tongue weight is 581 lbs it is within the range of your e2 Weight Distribution System. If you need to upgrade the bars you'd just need the 800 lb spring bars part #FA94-02-0899 and you'd be set.

view full answer...

Answer 4

When choosing the best weight distribution system for your trailer you will want your total tongue weight (TTW) which is composed of the loaded ready to tow weight of the trailer by any cargo stored behind the rear axle of the tow vehicle to fall in…

view full answer...

Answer 5

Yes, you can use Curt Weight Distribution Shank #C17124 with the Fastway e2 Weight Distribution System #FA94-00-0600 because the shank has the same hole spacing that the Fastway requires. The Curt shank will give your Fastway round bar system a…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 9

Weight distribution works to distribute the tongue weight of a trailer up to the front axle of the tow vehicle so that it will sit more level and handle/brake better. That being said the systems do not "reduce" tongue weight or allow you to…

view full answer...

Answer 10

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 11

The round or trunnion bars refers to the end of the spring bars. Round bars are typically designed for lighter applications, are a bit harder to install and are usually priced lower than trunnion bars. Trunnion bars are typically designed to be used…

view full answer...

Answer 12

The hitch ball angle adjustment on weight distribution systems is designed to provide more or less distribution of the tongue weight on your trailer hitch to the trailer and vehicle axles. If you adjust the ball angle farther away from the towing…

view full answer...