Diode Recommendation for Preventing Battery from Draining Other Battery
Question:
I have a John Deere Gator battery A and I pull a Trailer that has a separate battery B to operate a small Hydraulic pump to dump the trailer. I presently charge B by means of a jumper from A Can I install a RM 690 into the jumper wire to keep from drawing from battery Ainch ?. Basically using the RM 690 as a battery Isolator diode. Thank
asked by: Dennis R
Helpful Expert Reply:
The diode part # RM-690 that you referenced would be perfect for what you are looking to do. It will allow current to go from the one battery to other but not in the other direction. Basically you just need to install it between the two batteries with the in/out facing the right direction.
Product Page this Question was Asked From
Roadmaster Single Park Light Diode
- Accessories and Parts
- Tow Bar Wiring
- Diodes
- Roadmaster
more information >
Continue Researching
- Shop: Trailer Wiring
- Search Results: rm~690
- Shop: Brake Controller
- Video: Redarc Tow-Pro Liberty Brake Controller Installation - 2019 Toyota Highlander
- Shop: Redarc Tow-Pro Elite Brake Controller - Dash Knob - 2 Braking Modes - 1 to 3 Axles - Proportional
- Shop: Roadmaster Single Park Light Diode
- Article: Troubleshooting Brake Controller Installations
- Article: Trailer Wiring Diagrams
- Article: Brake Controller Installation: Starting from Scratch
- Article: How to Charge a Trailer Battery While Driving: 3 Common Problems (And How to Fix Them)
- Q&A: Diode Recommendation to Prevent Trailer Battery From Backfeeding onto Vehicle Wiring
- Shop: Redarc Tow-Pro Liberty Brake Controller - Dash Knob - 1 to 2 Axles - Proportional
- Shop: Roadmaster Battery Charge Line Kit for Towed Vehicles
- Shop: Universal Wiring Harness for Redarc Tow-Pro Trailer Brake Controllers
- Video: Redarc Tow-Pro Elite Trailer Brake Controller Installation - 2019 Toyota Highlander
- Q&A: Wiring Trailer for Two Batteries, Breakaway Battery and Auxiliary Battery
- Q&A: Is a Diode Required on the 12 Volt Pin for Charging a Trailer Battery
- Q&A: Is there a Way to Wire Trailer Rear Loading Lights to Work with Reverse Light Circuit on 7-Way
- Q&A: Is Diode Needed to Prevent Trailer Battery from Backfeeding to Breakaway System
- Q&A: What is the Voltage and Amperage Rating for Roadmaster Parking Light Diode
- Q&A: Parts Needed to Have 12V Trailer Battery Charging Circuit on 7-Way Connector
- Video: Roadmaster Single Park Light Diode Installation - 2016 Hyundai Elantra
- Video: Redarc In-Vehicle DC to DC Battery Charger Installation
- Video: Review of Redarc Trailer Brake Controller - Tow Pro Liberty Proportional Controller - RED24FR
- Video: Redarc Tow-Pro Elite Trailer Brake Controller Installation - 2018 Toyota Highlander
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Shop: Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Shop: Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Video: Curt T-Connector Vehicle Wiring Harness Installation - 2019 Toyota Highlander C56217
- Search Results: 44649