Recommended Wiring Harness For 2007 Jeep Patriot
Question:
I would like to know if following product is made in US 2007 Jeep Patriot Trailer Wiring Trailer Wiring x Separate wiring system - brake and turn signals are sent along separate wires. It is recommended to use a powered converter module to safeguard the vehicles wiring and support the trailer lights. Trailer Hitch Wiring Powered Converter Custom Fit 4 Flat
asked by: Antonio
Expert Reply:
If you want a wiring harness for your 2007 Jeep Patriot that is made in the USA, then the Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector # C55050 is the way to go. This harness will install the same way by connecting to the factory wiring with easy connectors located behind the tail lights of your Patriot. This harness will also draw power directly from your vehicle battery to protect your electrical system from overload.
Product Page this Question was Asked From
Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Powered Converter
- Custom Fit
- 4 Flat
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Trailer Wiring Harness for a 2008 Jeep Compass to Tow a Trailer with a 4-Way Connector
- Q&A: Recommendation For Hitch That Clears The Muffler On A 2010 Jeep Compass
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: What Ball Mount For Draw-Tite Class I Trailer Hitch Receiver, # 24769, on 2007 Dodge Caliber
- Q&A: How to Determine Which Drawbar I Need For My Vehicle
- Q&A: Wiring Diagram for Titan BrakeRite EHB Electric-Hydraulic Actuator # T4822500
- Article: Trailer Wiring Diagrams
- Article: Routing the Power Wire for a Trailer Wiring Harness
- Q&A: 2009 jeep compass installing trailer harness wirin
- Q&A: Wiring Diagram for a 7-Way Round Pin Trailer Connector on a 40 Foot Flatbed Trailer